Agilent Technologies FS2010 user manual 1680/90/900 Licensing

Page 12

Setting up the 1680/90/900 Analyzer

1680/90/900 Licensing

Loading 1680/90/900 configuration files

Connecting the 1680/90/9xx Agilent logic analyzer to the FS2010

The 1680/90/900 Analyzer is a PC based application that requires a PC running Windows OS with the Agilent logic analyzer software installed or a 16900 frame.

Before installing the protocol decoder for the PCI-X protocol on a PC you must install the Agilent logic analyzer software. Once the Agilent logic analyzer software is installed, you can install the FS2010 protocol decoder by placing the CD-ROM disk into the CD-ROM drive of the target computer or Analyzer and executing the .exe setup program that is contained on the disk. The .exe setup file can be executed from within the File Explorer PC Utility. You must navigate to the .exe file on the CD- ROM disk and then double click the .exe file name from within the File Explorer navigation panel.

The installation procedure does not need to be repeated. It only needs to be done the first time the Analysis Probe Adapter is used.

The PCI Inverse Assembler is a licensed product that is locked to a single hard drive. The licensing process is performed by Agilent. There are instructions on this process on the 16900 SW Entitlement certificate provided with this product.

When the software has been licensed you should be ready to load a configuration file. You can access the configuration files by clicking on the folder that was placed on the desktop. When you click on the folder it should open up to display all the configuration files to choose from. If you put your mouse cursor on the name of the file a description will appear telling you what the setup consists of, once you choose the configuration file that is appropriate for your configuration the 16900 operating system should execute. The protocol decoder automatically loads when the configuration file is loaded. If the decoder does not load, you may load it by selecting tools from the menu bar at the top of the screen and select the decoder from the list.

For a diagram on logic analyzer cable attachment to the probe click the properties button on the General Purpose Probe icon from the overview tab. When you click the Properties button another window will open showing what pods are attached to each cable. If you select one of the entries from the list in the window another window will open up showing the signal name on each pin of the connector the cables are attached to.

Refer to the table on page 9 for a list of analyzers and corresponding configuration files.

12

Image 12
Contents Page FS2010 Software and Timing mode J2 Signal Connector How to reach us Product Warranty Limitation WarrantyAssistance How to Use This Manual IntroductionAccessories Supplied Analyzing the PCI-X Local BusPage Configuration Files Connecting the 167xx Agilent logic analyzer to the FS2010 How to install a PCI-X add-in card into the FS2010Setting up the 167xx Analyzer 167xx Licensing 1680/90/900 Licensing Offline Analysis Page Page Format Menu PCI-X Transaction Decode Software FS2010 Software and Timing mode Cycle variable DEVSEL# TRDY# STOP# State Analysis Acquiring DataConfiguring the Workspace for PCI-X Analysis State Listing Display Above figure shows the listing from the 169xx frame Functionality FS2010 Transaction Decode Software Name Base DescriptionTiming Analysis Waveform Display Use of EyeFinder/Eyescan Transaction Viewer Characteristics General InformationSignal Connections State/Timing Adapter Probe interface pinoutJ2 Signal Connector INTD# J3 Signal Connections SERR# J4 Signal Connections Samtec