Agilent Technologies FS2010 user manual

Page 15

After the decoder has loaded, select Preferences if required, from the overview screen and set the preferences to their correct value in order to decode the trace properly. This is a general requirement, some decoders do not have preferences, and if this is the case then no preference setting is necessary.

Image 15

Contents Page FS2010 Software and Timing mode J2 Signal Connector How to reach us Product Warranty Limitation WarrantyAssistance Introduction How to Use This ManualAnalyzing the PCI-X Local Bus Accessories SuppliedPage Configuration Files How to install a PCI-X add-in card into the FS2010 Connecting the 167xx Agilent logic analyzer to the FS2010Setting up the 167xx Analyzer 167xx Licensing 1680/90/900 Licensing Offline Analysis Page Page Format Menu PCI-X Transaction Decode Software FS2010 Software and Timing mode Cycle variable DEVSEL# TRDY# STOP# Acquiring Data State AnalysisConfiguring the Workspace for PCI-X Analysis State Listing Display Above figure shows the listing from the 169xx frame Name Base Description Functionality FS2010 Transaction Decode SoftwareTiming Analysis Waveform Display Use of EyeFinder/Eyescan Transaction Viewer General Information CharacteristicsState/Timing Adapter Probe interface pinout Signal ConnectionsJ2 Signal Connector INTD# J3 Signal Connections SERR# J4 Signal Connections Samtec