Analyzing the PCI-X Local Bus

Accessories

Supplied

Minimum Equipment Required

Additional Equipment Required

This chapter introduces you to the FS2010 and lists the minimum equipment required and accessories supplied for PCI-X Local Bus analysis. This chapter also contains information that is common to both state and timing analysis.

The FS2010 product consists of the following accessories:

•The FS2010 probe.

•1 Diskette containing the configuration files and the FS2010 PCI-X decoder for 167xx analyzer.

•A CD containing the setup file to install the configuration files and protocol decoder on the 1680/90/900 analyzer or to use as an offline viewer.

•This operating manual on CD, Quick Start sheet, and SW Entitlement certificates for the software.

The minimum equipment required for analysis of a PCI-X Local Bus consists of the following equipment:

•Agilent 16700 analysis frame with the 16715 analyzer card or better.

•Revision 2.80.00 or better of the Agilent Logic analysis frame software.

•1680/90/900 Logic analyzer or PC containing Agilent 1680/90/900 OS version 3.00.00 or better.

•The FS2010 Product

•A PCI-X target bus

The type of logic analyzer card used will determine the correct type of termination adapter needed. For analyzer cards that use the 40 pin header, 1671x, 1674x, 16750/1/2, 1691x you will need the E5385A (FuturePlus number is FS1015) termination adapter cables. For analyzer cards that use the 90 pin header, 16753/4/5/6, 1695x you will need the E5378A (FuturePlus number is FS1014) termination adapter. A total of 3 adapter cables are required for 64 bit data width capture.