Agilent Technologies FS2010 user manual State Analysis, Acquiring Data

Page 21

State Analysis

Acquiring Data

This chapter explains how to configure the FS2010 to perform state analysis on the PCI-X Local Bus. The configuration software sets up the format specification menu of the logic analyzer for compatibility with the PCI-X Local Bus. The next chapter explains how to configure the FS2010 to perform timing analysis.

The FS2010 State/Timing Adapter Probe interface does not require that a PCI-X add-in card be installed in the FS2010 card edge extender connector.

Load the logic analyzer configuration file and configure the workspace for PCI-X analysis.

Configure the trigger menu to acquire PCI-X data. Select RUN and, as soon as there is activity on the bus, the logic analyzer will begin to acquire data. The analyzer will continue to acquire data and will display the data when the analyzer memory is full; the trigger specification is TRUE or when you select STOP.

The logic analyzer will flash “Slow or Missing Clock” if it does not see the PCI-X signal CLK toggling.

The logic analyzer will flash “Waiting in level 1” if the trigger specification has not been met.

If you are analyzing a 32 bit bus, load the configuration file for a 64 bit bus into a single analyzer card, the upper 64 bit labels will be truncated, but will work fine.

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Page FS2010 Software and Timing mode J2 Signal Connector How to reach us Product Warranty Limitation WarrantyAssistance Introduction How to Use This ManualAnalyzing the PCI-X Local Bus Accessories SuppliedPage Configuration Files How to install a PCI-X add-in card into the FS2010 Connecting the 167xx Agilent logic analyzer to the FS2010Setting up the 167xx Analyzer 167xx Licensing 1680/90/900 Licensing Offline Analysis Page Page Format Menu PCI-X Transaction Decode Software FS2010 Software and Timing mode Cycle variable DEVSEL# TRDY# STOP# Acquiring Data State AnalysisConfiguring the Workspace for PCI-X Analysis State Listing Display Above figure shows the listing from the 169xx frame Name Base Description Functionality FS2010 Transaction Decode SoftwareTiming Analysis Waveform Display Use of EyeFinder/Eyescan Transaction Viewer General Information CharacteristicsState/Timing Adapter Probe interface pinout Signal ConnectionsJ2 Signal Connector INTD# J3 Signal Connections SERR# J4 Signal Connections Samtec
Top Page Image Contents