Xerox FS 5250 IPC Changing Page Format, ??% %Y10,n1,n2% &&??space, Value n2 Tray

Selected FSL Functions

Xerox FS 5250, User’s Guide

Note: The option 2, COR, is printed in Landscape orientation with reduced vertical and horizontal spacing. Vertical spacing is 70 % of normal, thus reducing as follows:

10 pitch fonts will be converted to 13 pitch

12 pitch fonts will be converted to 15 pitch

15 pitch fonts will be converted to 20 pitch

17 pitch fonts will be converted to 27 pitch

11.3.2 Changing Page Format

The page format command has two parameters. You send the command as follows:

&&??% %Y10,<n1>[,n2]% &&??<space>

The command &&??% selects the character "%" as the escape character. The escape character is a signal to the interface that the data stream following is a command stream. The n1 is described at the previous page. The last command in the above line (&&?? <space>) erases the escape character again.

You do not have to enter an n2 value. If no parameter is entered for n2, the n1 value will be used for all trays. If you wish the n1 value to be used for a specific tray only, you must enter one of the following values:

Value (n2) Tray

1Tractor

2Tray 1

3Tray 2

4Manual feed

5Envelope feed

6Tray 3

7Tray 4

Saving the command

When you have changed the paper tray, you can tell the interface to remember the command. You do this by adding the %X1 to the command illustrated above.

NOTE:

This command also erases the escape character.

- 43 -