Belkin F6C1000-EUR, F6C700-EUR, F6C1400-EUR Load Level Display, Battery Level Display

P73335u_UPS_man.qxd 4/30/01 12:19 PM Page 12

Operation (continued)

4-6 Load Level Display

The 4-LED load percentage display shows the power level (20%, 40%, 60%, 80%) drawn by the loads from the UPS. If the UPS is overloaded, the OVERLOAD LED will light.

4-7 Battery Level Display

This display shows the battery capacity left in the battery. The level is represented by percentages of 25, 50, 75, and 100. These LED will extinguish gradually when using battery power. When battery capacity reaches the minimal level of 25%, the lowest LED (25%) blinks and there is an immediate need to charge the battery. Under this condition, the battery can only supply less than five minutes of run time for the load.

4-8 If certain abnormal conditions occur, the UPS will send the following messages:

ON BATTERY MODE: When the UPS is in ON BATTERY MODE, the ON BATTERY LED will light, preceded by a beep every two seconds, and then the UPS will start supplying power to the load through the battery.

12