Belkin F6C1000-EUR, F6C700-EUR, F6C1400-EUR user manual Battery Replacement Procedures

Page 21

P73335u_UPS_man.qxd 4/30/01 12:19 PM Page 17

Replacing Battery (continued)

The Regulator PRO™ NetUPS Series provides a convenient and easy way to replace batteries. If batteries are in poor condition, follow the proper procedure for battery replacement.

6-1 Notice

•When replacing batteries, always use the same type as the previous one.

•Do not dispose the battery or batteries in a fire as they may explode.

•Do not open or mutilate the battery or batteries as released electrolyte is toxic and harmful to skin and eyes.

•A battery may present a risk of electric shock and high short circuit current. The following precaution should be observed when replacing batteries:

•Remove watches, rings, or other metal objects.

•Use tools with insulated handles.

6-2 Battery Replacement Procedures

1.Hold the top of the front panel, tilt it out and pull it carefully away from the chassis.

Step 1

Grasp and tilt out and down

En

2.Loosen the bottom of the front panel from the chassis and place it on the top of the UPS. Be cautious so as not to pull the ribbon cable and touch the LED printed circuit board.

3.Use a Phillips screwdriver to remove and open the battery door.

4.Carefully and smoothly pull the battery out of the UPS.

Step 2

Place the front panel above

Step 4

Pull battery out

Step 3

Use a Phillips screwdriver to release the battery door

17

Image 21

Contents UPS P73335uUPSman.qxd 30/01 1219 PM Language Table of Contents Table of Contents TUV Safety Instruction Important Safety InstructionsSafety Instructions Introduction SymbolsTheory of Operation Block Diagram of Line Interactive UPSAnnotation Front Panel Rear Panel Introduction Before Installation InstallationInstallation UnpackingInstallation Operation Load Level Display Battery Level DisplayBattery Replace OverloadBUCK/BOOST Short Circuit Battery LOWUPS Fault Over TemperatureReplacing Battery MaintenanceBattery Replacement Procedures Black Black 1000VA 700VA Red + Push back to UPS Problem Possible Cause Solution TroubleshootingBUCK, Boost Communication Interface Hardware Parity None Cabling Computer UPSGND Low Battery Battery SpecificationsElectrical Input Electrical OutputMechanical InterfacePhysical ApprovalAppendix a Typical Run Time FCC Statement InformationBelkin Components Table des matières P73335f-UPS-man.qxd 30/01 1222 PM Consignes de sécurité TUV Consignes de sécurité importantesDéclaration de conformité EC Consignes de sécurité suiteSymboles Théorie de fonctionnement Introduction suiteCommentaire Face avant Face arrière Face arrière du modèle F6C700-EUR Déballage Avant de commencer linstallationInstallation suite Fonctionnement Fonctionnement suite Affichage du niveau de chargeAffichage du niveau des batteries Battery Replace Remplacer LA Batterie Overload SurchargeBUCK/BOOST BAISSE/HAUSSE DE Tension Short Circuit COURT-CIRCUIT Battery LOW Batterie FaibleUPS Fault Dysfonctionnement DE Londuleur Over Temperature Temperature ExcessiveRemplacement de la batterie Remplacement de la batterie suite Procédure de remplacement des batteriesAvertissement Noir 1000VA 700VA Rouge + « ON/TEST » DépannageRemplacer LA Dépannage suiteInterface de communication Materiel Interface de communication suiteLongueur DES Donnees BIT DarretBatterie faible Mise hors tension Panne CA Alimentation Dentree SpécificationsPuissance EN Sortie BatterieMecanique Spécifications suitePhysique CertificationAnnexe a Fonctionnement normal Information Belkin Components Abschnitt Seite InhaltsverzeichnisP73335g-UPS-man.qxd 30/01 1224 PM TÜV-Sicherheitshinweise Wichtige SicherheitshinweiseSicherheitsvorschriften Forts Einführung SymboleFunktionsbeschreibung Einführung FortsKonventionen Vorderseite Rückseite Rückseite F6C700-EUR Auspacken des Geräts Vor der InstallationInstallation Fortsetzung Bedienung Lastanzeige Bedienung FortsetzungBatterieladezustand Bei Unregelmäßigkeiten gibt die USV folgende Meldungen ausBedienung Fortsetzung Bedienung Fortsetzung Bedienung Fortsetzung Batteriewechsel Pflege und WartungBatteriewechsel Forts HinweisVorgehensweise zum Wechseln der Batterien Schwarz 700VA Rot + 1000VA USV einlegen Fehler Mögliche Ursache Lösung FehlerbehebungFehlerbehebung Forts NORMAL, on BatterySerielle Schnittstelle Stopbit Serielle Schnittstelle FortsKeine Verkabelung Computer USV ErdeSignal Erde Technische Daten NetzeingangStromausgang Technische Daten Forts Anhang a Typische Laufzeit FCC Behauptung Belkin Components