Belkin F6C1000-EUR, F6C700-EUR, F6C1400-EUR Troubleshooting, Problem Possible Cause Solution

P73335u_UPS_man.qxd 4/30/01 12:19 PM Page 19

7. Troubleshooting

PROBLEM	POSSIBLE CAUSE	SOLUTION
UPS is not turned on.	ON/TEST button is not	Press the ON/TEST
(No alarm, no LED lights.)	pushed.	button to turn on the
		UPS. (Refer to section 4
		to turn on the UPS.)
	The rear panel circuit	1. Reduce some loads
	breaker is tripped. (Button
		connected to the UPS
	is out.)
		2. Reset the circuit
		breaker. (Push
		button in.)
	UPS fault	Call for qualified service
		personnel if above
		actions do not solve the
		problem.
	Batteries inside the UPS	Recharge the batteries
		for at least four hours.
	are not fully charged.
UPS does not provide	UPS is overloaded.	Remove some
expected back-up time.		unnecessary loads.
	Batteries are weak.	Batteries wear faster
		when used often or
		operating at higher
		temperature.
		If the battery is near
		the end of its life,
		replace the battery
		even if the REPLACE
		BATTERY LED does not
		light. (Refer to section 6
		for replacing batteries.)
	Batteries are weak.	Call for service.

En

19