Belkin PM01110 user manual Using the Web-Based Advanced User Interface

Using the Web-Based Advanced User Interface

Table of Contents sections 1 2 3 4 5 6 7 8 9 10

3.Place your secondary Access Point within range of your Router and near the area where you want to extend the range or add the network segment. Typically, indoor range should be between 100 and 200 feet.

4.Connect power to your Access Point. Make sure the Access Point is on and proceed to the next step.

5.From a computer already connected to your Router, access the Advanced Setup Utility by opening your browser. In the address bar, type in “192.168.2.1”. Do not type in “www” or “http://” before the number. Note: If you have changed your Router’s IP address, use that IP address.

6.You will see the Router’s user interface in the browser window. Click “Wireless Bridge” on the left-hand side of the screen. You will see the following screen.

G Wireless Router 63