3M 803 Specifications, Operating Temperature, Storage Temperature, Humidity, Memory Card

Page 11
Specifications

Specifications

Operating Temperature

Typical ambient temperature range: 50°F to 104°F (10°C to 40°C)

 

 

Storage Temperature

-40°F to 131°F (-40°C to 55°C)

 

 

Humidity

0% to 85% RAH, non-condensing

 

 

Memory Card

Type I or Type II CompactFlashTM card

 

(A 64-MB memory card stores data for approximately 460,000 items.)

 

 

Battery type

Only use a Molicel MCR-1821 battery rated at 2400mAh or greater.

 

 

Battery charger

Only use a Molicel MAC-1821B battery charger.

 

 

Typical charge life

A fully charged battery will last for approximately three to four hours of

 

"trigger time" (time the trigger is pressed or activated). This typically

 

provides many hours of use before recharging is required.

 

 

Typical time to fully charge

The battery charger will charge a fully discharged battery in approximately

a battery

four hours.

 

 

Battery Charger Power

100-240 Vac, 1.0A, 50-60 Hz

 

 

7

Image 11
Contents Copyright 2003-2010 3M. All rights reserved Track and Trace SolutionsHandheld RFID Reader Model Owner’s Manual78-8126-8363-5 Rev C 3M Handheld RFID Reader Model 803 Owner’s Manual2003-2010 3M. All rights reserved 3M is a trademark of 3MHandheld RFID Reader Safety informationBattery Management Requesting servicePage EXPLANATION OF SIGNAL WORD CONSEQUENCES Safety informationIntended use Attention Read accompanying documentation Risk of Electric ShockTo reduce the risk associated with fire and explosion Safety messagesIMPORTANT NOTES Do not over tighten the antenna adjustment screwAlways use the Change Battery function when you change the battery Important notesPWR COM/STATUS Safety label locationsN1108 ModelFCC Intentional Radiator Certification EMC, USA, and Canada complianceJapan FCC Radio Frequency Rules and RegulationsGetting started Using the 3M Handheld RFID Reader for the first timeStep 2 - Charge the battery and insert it into the Handheld 1 See Charging the battery on pagea battery SpecificationsBattery type Battery chargerAdjustment Handheld componentsFigure 1 Handheld components Antenna Indicator Lights Scroll Buttons Menu Buttons AntennaFigure 2 The Handheld includes a menu-driven display screen Controls and indicators2 - Insert the memory card 1 - Install a pull tab on the memory cardDatabase Errors Inserting the memory cardRemoving the memory card ProcedureFigure 6 Handheld reset button Resetting the HandheldTo reset the Handheld If pressing the reset button did not work…Figure 7 If the Handheld displays database Formatting a memory cardUsing the 3M Handheld RFID Reader for the first time Adjusting the antennaCleaning the Handheld Figure 8 Use the antenna adjustment tool to adjust the antennaFigure 9 Battery charging system Battery ManagementBattery charging guidelines Battery useBattery Charger Status Light Charging the batteryTo charge a battery a Connect the power supply output to the charger standFigure 12 Before removing a battery, select Change Battery Replacing the batteryRemoving the battery Installing the batteryFor software support Requesting service3M Service phone numbers For serviceDescription Ordering replacement partsStock Number