3M 803 owner manual Replacing the battery, Removing the battery, Installing the battery

Replacing the battery

Removing the battery

1From the Handheld software’s Home menu, select Change Battery.

Important Note! - If you do not use the Change Battery function, you may lose collected data and/or corrupt the memory card. Also, you may have to reset the Handheld.

2When the screen goes blank, it is safe to remove the battery.

3Push the battery tab down, away from the battery.

4Slide the battery out of the battery holder.

Installing the battery

1 Select "Change Battery" from the main screen

2 Remove the old battery

Press the	Remove the Battery
Battery
Tab

3 Insert the new battery

1Insert the battery into the battery holder as shown.

2Make sure that the battery tab securely holds the battery in place.

	Make sure that the
Insert the Battery	battery tab securely	702_006
	holds the battery in place

Figure 12: Before removing a battery, select Change Battery.

WARNING

To reduce the risk associated with fire and explosion:

Do not attempt to use a damaged battery pack, charger, or power supply;

Do not allow battery pack to come in contact with water;

Do not disassemble, crush, or incinerate the battery pack — at the end of service life, dispose of the battery pack in accordance to federal, state and local requirements;

Replace battery pack with Molicel MCR-1821 type battery pack only;

Do not store the battery pack in areas that may exceed temperatures of 100°C/212°F;

Use the charger with the supplied power supply only.

To reduce the risk associated with hazardous voltage contained within the battery charger:

Do not use the charger or power supply if the case or cord are damaged;

Do not use in outdoor or wet environments;

Do not attempt to service or repair the charger or power supply — no user serviceable parts inside.

17