3M 803 Resetting the Handheld, To reset the Handheld, If pressing the reset button did not work…

Page 16

Resetting the Handheld

If the Handheld display locks up or stops working, perform the reset procedure described below.

A blank screen may be caused by a fully discharged battery.

To reset the Handheld

1Insert a memory card (with 3M Handheld software on it) into the Handheld.

2Press and hold the reset button for approximately one second.

3The Handheld software loads.

4The Home screen appears.

If pressing the reset button did not work…

1Insert a memory card (with 3M Handheld software on it) into the Handheld.

2Remove the battery.

3Insert a fully charged battery.

4Follow the Using the 3M™ Handheld RFID Reader for the first time procedure on page 6.

Reset

Button

702_012

Figure 6: Handheld reset button.

Image 16

Contents Track and Trace Solutions Handheld RFID Reader ModelOwner’s Manual Copyright 2003-2010 3M. All rights reserved3M Handheld RFID Reader Model 803 Owner’s Manual 2003-2010 3M. All rights reserved3M is a trademark of 3M 78-8126-8363-5 Rev CSafety information Battery ManagementRequesting service Handheld RFID ReaderPage Safety information Intended useAttention Read accompanying documentation Risk of Electric Shock EXPLANATION OF SIGNAL WORD CONSEQUENCESSafety messages To reduce the risk associated with fire and explosionDo not over tighten the antenna adjustment screw Always use the Change Battery function when you change the batteryImportant notes IMPORTANT NOTESSafety label locations N1108Model PWR COM/STATUSEMC, USA, and Canada compliance JapanFCC Radio Frequency Rules and Regulations FCC Intentional Radiator CertificationUsing the 3M Handheld RFID Reader for the first time Step 2 - Charge the battery and insert it into the Handheld1 See Charging the battery on page Getting startedSpecifications Battery typeBattery charger a batteryHandheld components Figure 1 Handheld componentsAntenna Indicator Lights Scroll Buttons Menu Buttons Antenna AdjustmentControls and indicators Figure 2 The Handheld includes a menu-driven display screen1 - Install a pull tab on the memory card Database ErrorsInserting the memory card 2 - Insert the memory cardProcedure Removing the memory cardResetting the Handheld To reset the HandheldIf pressing the reset button did not work… Figure 6 Handheld reset buttonFormatting a memory card Figure 7 If the Handheld displays databaseAdjusting the antenna Cleaning the HandheldFigure 8 Use the antenna adjustment tool to adjust the antenna Using the 3M Handheld RFID Reader for the first timeBattery Management Battery charging guidelinesBattery use Figure 9 Battery charging systemCharging the battery To charge a batterya Connect the power supply output to the charger stand Battery Charger Status LightReplacing the battery Removing the batteryInstalling the battery Figure 12 Before removing a battery, select Change BatteryRequesting service 3M Service phone numbersFor service For software supportStock Number Ordering replacement partsDescription