Atlona AT-HD88M-SR manual IR Extenders, IR Sockets, IR Blaster IR Receiver

Page 11

￿￿￿￿'￿￿￿#￿￿￿￿￿*￿￿

IR Extenders

IR Blaster

 

IR Receiver

￿ ￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

IR Sockets

AT-HD88M-S

IR Main: The default location for IR blaster to transmit all IR command signals received from any of the eight remote receivers to all of the HDMI sources.

IR PASS-THROUGH18: IR blaster connected here can only transmit IR command signals from the remote receivers that are setting at respective input channel from 1 to 8.

AT-HD88M-R

IR RECEIVER: IR receiver connected here can receive all IR command signals from the IR remote controls of AT-HD88M-SR and all other HDMI source devices.

9

Image 11
Contents Page $! % Page Features AT-HD88M-SR Mode H Panel Hold and Unhold Mode Selection 1, 2, 3, 4, 5, 6, 7, 8, E, H, L, 1Mode 1-8 Preset Profiles Mode E Edid Learning ModeRear Panel of AT-HD88M-S Mode L System Lock and UnlockAT-HD88M-R SW1-SW8 for EDID/Audio SW Main for firmware update for technical support only IR Blaster IR Receiver IR ExtendersIR Sockets IR Blaster Definition of IR Earphone JackSupported IR Data Format AT-HD88M-R as receiver unit AT-HD88M-S as master unitMethod a Push-in Button Method B IR Remote ControlSource Side Display Side Method a Push-in button for switching input channelsMethod B1 IR remote control for switching input channels Scan button Method C Software Control through RS-232 serial portMapping button Setting buttonLinkage button Open/Close buttonCommand Set One by one settingGroup setting By using TerminalMethod a Manually connect Hdmi display to Hdmi Input Method B Using Front PanelCustom Code IR3 0x12 Custom Code 0x12 Custom Code 01 EE 14-key IR remote default 01 EEReceiver Unit Master Unit 0x01 0xEE Custom Code IR4 0x13 Custom Code 0x13 Command Custom CodeSafeguards Limited Warranty