Atlona AT-HD88M-SR manual Method C Software Control through RS-232 serial port, Scan button

Page 16

&& !&!

Method C: Software Control through RS-232 serial port

Input &	Output port
Source indicator

Software Control Menu Status Indicator

1.Scan button:

Serial Port Scan:

Press Scan button, the machine will scan the all com port and show them.

Select the RS-232 serial port connected to the machine. And set device ID 255 is for all device. Only the same device ID or 255 can get the command you sent.

Press OK to get the new status from the machine you select.

Image 16

Contents Page $! % Page Features AT-HD88M-SR Mode Selection 1, 2, 3, 4, 5, 6, 7, 8, E, H, L, 1 Mode 1-8 Preset ProfilesMode E Edid Learning Mode Mode H Panel Hold and UnholdMode L System Lock and Unlock Rear Panel of AT-HD88M-SAT-HD88M-R SW1-SW8 for EDID/Audio SW Main for firmware update for technical support only IR Sockets IR ExtendersIR Blaster IR Receiver Supported IR Data Format Definition of IR Earphone JackIR Blaster AT-HD88M-S as master unit AT-HD88M-R as receiver unitSource Side Method B IR Remote ControlMethod a Push-in Button Method B1 IR remote control for switching input channels Method a Push-in button for switching input channelsDisplay Side Method C Software Control through RS-232 serial port Scan buttonSetting button Linkage buttonOpen/Close button Mapping buttonOne by one setting Group settingBy using Terminal Command SetMethod B Using Front Panel Method a Manually connect Hdmi display to Hdmi InputReceiver Unit Master Unit 0x01 0xEE Custom Code 01 EE 14-key IR remote default 01 EECustom Code IR3 0x12 Custom Code 0x12 Command Custom Code Custom Code IR4 0x13 Custom Code 0x13Safeguards Limited Warranty