Star Micronics TUP452-24, TUP482-24 operation manual

Page 10

Notes) Use paper that is rolled inward.

Do not affix the end of the paper to the paper roller.

Paper jams may occur depending on the paper quality used and the pattern printed.

If the machine is turned off and left for a long time with paper caught in the thermal head, the paper should be removed and inserted again.

Keep this machine on a level surface.

The roller may leave short marks in the end of the paper.

The cash drawer cannot be used when the PR112 (presenter) is installed.

– 6 –

Image 10 Contents
TUP452-24 TUP482-24 Page Contents Page General Description TUP4 Configuration Construction Principle of Operation Exterior View General Specifications AsciiTF50KS-E Paper Roll SpecificationsTF62KS-E Page Printer Settings Switches and ButtonsOFF Setting the DIP SwitchesDTR XON/XOFF DIP switch 2 only for the RS-422A DC1, 3 disabled Address #1 Setting the Eeprom USAIBM LEDs Power Switch and Button CombinationsDisplays and Functions Resume ButtonSensor Adjusting Mode Near-End SensorError Messages LED ERRNear-End Sensor Position Interface Serial Interface RS-232C or RS-422ASD + Parallel Interface Cutter Presenter TUP482 series only Characters and Sizes CharactersCharacter Set OCR-BPower Requirements JST. VHR-4N Noise Standards During operation ReliabilityDuring storage Vibration Test Allowable Static Electricity LevelDrop Test Life Test McbfInstalling the Paper Roll OpenPress Installation Installation procedureInstallation precautions 16.2Other precautionsWideth 25PAPER.8 Surface Installation Hole Dimensions Maintenance Timing Maintenance ProceduresPage Distributed by