Star Micronics TUP452-24, TUP482-24 operation manual Setting the DIP Switches, Off, Dtr Xon/Xoff

Page 12

5.2 Setting the DIP Switches

All of the DIP switches have been set to ON at the time of shipping.

a) DIP switch 1 (for both RS-232C and RS-422A)

Switch position		Function		ON	OFF

1-1			Baud rate
1-1			Baud rate
1-2
1-2
1-3	Handshaking			DTR	XON/XOFF
1-4	Data length			8 bits	7 bits
1-5	Parity			Disabled	Enabled
1-6	Parity			Odd	Even
1-7	DC1, 3 (*1)			Disabled	Enabled
1-8	Power on (*2)

*1 Only for the RS-232C (This setting is made with DIP switch 2 on the RS-422A.) *2 For the power on function

			1-8 ON		1-8 OFF
When DC1, 3 is disabled			Select		Select
When DC1, 3 is enabled			Select		Deselect
When addressable			Deselect		Select

Baud rate		1-1	1-2

2400BPS		OFF	OFF
4800BPS		OFF	ON
9600BPS		ON	ON
19200BPS		ON	OFF

– 8 –

Image 12

Contents

TUP452-24 TUP482-24 Page Contents Page General Description TUP4Construction ConﬁgurationPrinciple of Operation Exterior View General Specifications AsciiPaper Roll Specifications TF50KS-ETF62KS-E Page Printer Settings Switches and ButtonsSetting the DIP Switches OFFDTR XON/XOFF DIP switch 2 only for the RS-422A DC1, 3 disabled Address #1 Setting the Eeprom USAIBM Power Switch and Button Combinations Displays and FunctionsLEDs Resume ButtonSensor Adjusting Mode Near-End SensorError Messages LED ERRNear-End Sensor Position Interface Serial Interface RS-232C or RS-422ASD + Parallel Interface Cutter Presenter TUP482 series only Characters Character SetCharacters and Sizes OCR-BPower Requirements JST. VHR-4N Noise Standards Reliability During operationDuring storage Allowable Static Electricity Level Vibration TestDrop Test Life Test McbfInstalling the Paper Roll OpenPress Installation Installation procedureInstallation precautions 16.2Other precautionsWideth 25PAPER.8 Surface Installation Hole Dimensions Maintenance Timing Maintenance ProceduresPage Distributed by