Star Micronics TUP452-24, TUP482-24 operation manual

Page 2

NOTICE

All rights reserved. Reproduction of any part of this manual in any form whatsoever, without STAR’s express permission is forbidden.

The contents of this manual are subject to change without notice.

All efforts have been made to ensure the accuracy of the contents of this manual at the time of going to press. However, should any errors be detected, STAR would greatly appreciate being informed of them.

The above notwithstanding, STAR can assume no responsibility for any errors in this manual.

©Copyright 1996 Star Micronics Co., LTD.

Image 2 Contents
TUP452-24 TUP482-24 Page Contents Page General Description TUP4Principle of Operation ConstructionConfiguration Exterior View General Specifications AsciiTF62KS-E Paper Roll SpecificationsTF50KS-E Page Printer Settings Switches and ButtonsDTR XON/XOFF Setting the DIP SwitchesOFF DIP switch 2 only for the RS-422A DC1, 3 disabled Address #1 Setting the Eeprom USAIBM LEDs Power Switch and Button CombinationsDisplays and Functions Resume ButtonSensor Adjusting Mode Near-End SensorError Messages LED ERRNear-End Sensor Position Interface Serial Interface RS-232C or RS-422ASD + Parallel Interface Cutter Presenter TUP482 series only Characters and Sizes CharactersCharacter Set OCR-BPower Requirements JST. VHR-4N Noise Standards During storage ReliabilityDuring operation Drop Test Allowable Static Electricity LevelVibration Test Life Test McbfInstalling the Paper Roll OpenPress Installation Installation procedureInstallation precautions 16.2Other precautionsWideth 25PAPER.8 Surface Installation Hole Dimensions Maintenance Timing Maintenance ProceduresPage Distributed by