Star Micronics TUP482-24, TUP452-24 operation manual Installation procedure

Page 35

16. INSTALLATION

Installation procedure

Install the printer using four M4 bolts as shown in the illustration below. (Refer to the diagram of the

“Installation Hole Dimensions”.)

Unit printer

Sheet metal, rail, etc.

M4

– 31 –

Image 35

Contents

TUP452-24 TUP482-24 Page Contents Page TUP4 General DescriptionPrinciple of Operation ConstructionConﬁguration Exterior View Ascii General SpecificationsTF62KS-E Paper Roll SpecificationsTF50KS-E Page Switches and Buttons Printer SettingsDTR XON/XOFF Setting the DIP SwitchesOFF DIP switch 2 only for the RS-422A DC1, 3 disabled Address #1 USA Setting the EepromIBM Resume Button Power Switch and Button CombinationsDisplays and Functions LEDsNear-End Sensor Sensor Adjusting ModeLED ERR Error MessagesNear-End Sensor Position Serial Interface RS-232C or RS-422A InterfaceSD + Parallel Interface Cutter Presenter TUP482 series only OCR-B CharactersCharacter Set Characters and SizesPower Requirements JST. VHR-4N Noise Standards During storage ReliabilityDuring operation Drop Test Allowable Static Electricity Level Vibration Test Mcbf Life TestOpen Installing the Paper RollPress Installation procedure Installation16.2Other precautions Installation precautionsWideth 25PAPER.8 Surface Installation Hole Dimensions Maintenance Procedures Maintenance TimingPage Distributed by