8. CUTTER
Item | Specification |
|
|
Method | |
Drive method | DC motor |
Installation | Attached to the mechanism with screws |
Supply | Thickness of one sheet of paper: 60 to 85 ∝m |
Minimum cutting length | 25.4 mm (no presenter) |
| 80 mm (equipped with presenter) |
Life (standard paper) | 300,000 times |
| Paper debris must be removed. |
Error | An error occurs if the cutter has not returned to the home position within |
| the specified time. |
|
|
Notes) If the cutter is not located at the home position when an error has occurred, it can be returned to the home position by removing the cause of the error and turning the power off, then on again. The cutter can also be returned to the home position by turning off the power, inserting a screwdriver into the hole on the side of the cutter, then rotating the motor until the cutter is returned to the position which is believed to be the home position.
– 19 –