TRENDnet TEW-510APB manual Wireless MAC Filter, Wireless-A Setting

Page 14

4.4 Wireless MAC Filter

This function allows administrator to have access control by enter MAC address of wireless devices which transmitting within your wireless network.

Wireless-A Setting

Access Control List Mode: This drop-down menu can set Enable/Disable the ACL function.

Default Access: Select the default policy for this ACL rule.

Specific Clients list: Except the default rule, administrator can also create one policy for special client via Add ACL.

Wireless-B/G Setting

Access Control List Mode: This drop-down menu can set Enable/Disable the ACL function.

Default Access: Select the default policy for this ACL rule.

Specific Clients list: Except the default rule, administrator can also create one policy for special client via Add ACL.

Change these settings as described here and click the Apply button to apply your changes or click Cancel button to cancel your changes. For additional information, click Help.

User’s Guide

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents User’s Guide Copyright Statement MAYContents Introduction Safety Notification Front Panel Hardware InstallationPower 11a 11g Ethernet Rear Panel Reset Button Ethernet PowerAP Default Settings Hardware Installation for Connection to Your local network How to Configuring the Dual Band AP Turn on Power SupplyStatic IP Setup Network SetupNetwork Setup Wireless Wireless Settings Wireless-A SettingsUser’s Guide Wireless Wireless Mode Wireless MAC Filter Wireless-A SettingSecurity Mode Wireless Wireless SecurityWireless Security WPA onlyWireless-A Settings Authentication Type Wireless Advanced Wireless SettingsAdvanced Wireless Wireless-B/G Settings Authentication Type User’s Guide Administration Management Backup and RestoreAdministration Reboot AP Administration Firmware Upgrade Firmware UpgradeAdministration Factory Defaults Factory DefaultsLocal Area Network Status Local NetworkIdentity Wireless-B/G Settings Status Wireless NetworkWireless Settings Wireless-A Settings Status Wireless Statistics Can’t access the AP from a wireless client. Answer Troubleshooting Q & aHow to set the AP to factory default setting. Answer My AP will not turn on. No LED’s light up AnswerLimited Warranty Federal Communication Commission Interference Statement FCC Radiation Exposure StatementUser’s Guide
Top Page Image Contents