TRENDnet TEW-510APB manual Administration Reboot AP

Page 20

4.8 Administration – Reboot AP

AP Reboot: Click this button to initialize this device.

User’s Guide

20

Image 20

Contents User’s Guide Copyright Statement MAYContents Introduction Safety Notification Front Panel Hardware InstallationPower 11a 11g Ethernet Rear Panel Reset Button Ethernet PowerAP Default Settings Hardware Installation for Connection to Your local network How to Configuring the Dual Band AP Turn on Power SupplyStatic IP Setup Network SetupNetwork Setup Wireless Wireless Settings Wireless-A SettingsUser’s Guide Wireless Wireless Mode Wireless MAC Filter Wireless-A SettingWireless Wireless Security Wireless SecuritySecurity Mode WPA onlyWireless-A Settings Authentication Type Wireless Advanced Wireless SettingsAdvanced Wireless Wireless-B/G Settings Authentication Type User’s Guide Administration Management Backup and RestoreAdministration Reboot AP Administration Firmware Upgrade Firmware UpgradeAdministration Factory Defaults Factory DefaultsLocal Area Network Status Local NetworkIdentity Wireless-B/G Settings Status Wireless NetworkWireless Settings Wireless-A Settings Status Wireless Statistics Troubleshooting Q & a How to set the AP to factory default setting. AnswerCan’t access the AP from a wireless client. Answer My AP will not turn on. No LED’s light up AnswerLimited Warranty Federal Communication Commission Interference Statement FCC Radiation Exposure StatementUser’s Guide