TRENDnet TEW-510APB manual How to Configuring the Dual Band AP, Turn on Power Supply

Page 9

4. How to Configuring the Dual Band AP

TURN ON POWER SUPPLY

Quick power cycle would cause system corruption. When power on, be careful not to shut down in about 5 seconds, because data is writing to the flash.

START UP & LOGIN

In order to configure the Wireless 11ag AP, you must use web browser and manually input http://192.168.1.250 into the Address box and press Enter. The Main Page will appear.

In order to configure the Wireless 11ag AP, you must input the password into the Password box and leave blank on the User Name box. The default password is “admin”.

Once you have logged-in as administrator, it is a good idea to change the administrator password to ensure a secure protection to the Wireless 11ag AP. The Security Settings section described later in this manual describes how to change the password.

Once you have input the correct password and logged-in, the screen will change to the Setup page screen.

User’s Guide

9

Image 9

Contents User’s Guide MAY Copyright StatementContents Introduction Safety Notification Hardware Installation Power 11a 11g EthernetFront Panel Reset Button Ethernet Power AP Default SettingsRear Panel Hardware Installation for Connection to Your local network Turn on Power Supply How to Configuring the Dual Band APSetup Network Setup Network SetupStatic IP Wireless-A Settings Wireless Wireless SettingsUser’s Guide Wireless Wireless Mode Wireless-A Setting Wireless MAC FilterWireless Security Wireless Wireless SecuritySecurity Mode WPA onlyWireless Advanced Wireless Settings Advanced WirelessWireless-A Settings Authentication Type Wireless-B/G Settings Authentication Type User’s Guide Backup and Restore Administration ManagementAdministration Reboot AP Firmware Upgrade Administration Firmware UpgradeFactory Defaults Administration Factory DefaultsStatus Local Network IdentityLocal Area Network Status Wireless Network Wireless Settings Wireless-A SettingsWireless-B/G Settings Status Wireless Statistics How to set the AP to factory default setting. Answer Troubleshooting Q & aCan’t access the AP from a wireless client. Answer My AP will not turn on. No LED’s light up AnswerLimited Warranty FCC Radiation Exposure Statement Federal Communication Commission Interference StatementUser’s Guide