TRENDnet TEW-510APB manual Status Local Network, Identity, Local Area Network

Page 23

4.11 Status – Local Network

The Local Network screen on the Status Tab displays the status of your network.

Identity

Device Name: The device name for user identification.

Firmware Version: The current AP firmware version display here.

Local Area Network

Local MAC Address: This is the AP’s local physical MAC Address.

Connection Type: The current IP address type --- Dynamic or Static.

IP Address: The current AP’s IP address.

Subnet Mask: This is AP’s local subnet mask.

Default Gateway: This is the local network gateway IP.

User’s Guide

23

Image 23

Contents User’s Guide MAY Copyright StatementContents Introduction Safety Notification Front Panel Hardware InstallationPower 11a 11g Ethernet Rear Panel Reset Button Ethernet PowerAP Default Settings Hardware Installation for Connection to Your local network Turn on Power Supply How to Configuring the Dual Band APStatic IP Setup Network SetupNetwork Setup Wireless-A Settings Wireless Wireless SettingsUser’s Guide Wireless Wireless Mode Wireless-A Setting Wireless MAC FilterWPA only Wireless Wireless SecurityWireless Security Security ModeWireless-A Settings Authentication Type Wireless Advanced Wireless SettingsAdvanced Wireless Wireless-B/G Settings Authentication Type User’s Guide Backup and Restore Administration ManagementAdministration Reboot AP Firmware Upgrade Administration Firmware UpgradeFactory Defaults Administration Factory DefaultsLocal Area Network Status Local NetworkIdentity Wireless-B/G Settings Status Wireless NetworkWireless Settings Wireless-A Settings Status Wireless Statistics My AP will not turn on. No LED’s light up Answer Troubleshooting Q & aHow to set the AP to factory default setting. Answer Can’t access the AP from a wireless client. AnswerLimited Warranty FCC Radiation Exposure Statement Federal Communication Commission Interference StatementUser’s Guide