TRENDnet TEW-510APB manual Administration Factory Defaults

Page 22

4.10 Administration – Factory Defaults

This Factory Defaults allows you to restore the AP’s configuration to its factory default settings.

Factory Defaults

Restore Factory Defaults: Click this button to reset all configuration settings to their default values. Any settings you have saved will be lost when the default settings are restored.

User’s Guide

22

Image 22

Contents User’s Guide Copyright Statement MAYContents Introduction Safety Notification Power 11a 11g Ethernet Hardware InstallationFront Panel AP Default Settings Reset Button Ethernet PowerRear Panel Hardware Installation for Connection to Your local network How to Configuring the Dual Band AP Turn on Power SupplyNetwork Setup Setup Network SetupStatic IP Wireless Wireless Settings Wireless-A SettingsUser’s Guide Wireless Wireless Mode Wireless MAC Filter Wireless-A SettingSecurity Mode Wireless Wireless SecurityWireless Security WPA onlyAdvanced Wireless Wireless Advanced Wireless SettingsWireless-A Settings Authentication Type Wireless-B/G Settings Authentication Type User’s Guide Administration Management Backup and RestoreAdministration Reboot AP Administration Firmware Upgrade Firmware UpgradeAdministration Factory Defaults Factory DefaultsIdentity Status Local NetworkLocal Area Network Wireless Settings Wireless-A Settings Status Wireless NetworkWireless-B/G Settings Status Wireless Statistics Can’t access the AP from a wireless client. Answer Troubleshooting Q & aHow to set the AP to factory default setting. Answer My AP will not turn on. No LED’s light up AnswerLimited Warranty Federal Communication Commission Interference Statement FCC Radiation Exposure StatementUser’s Guide