TRENDnet TEW-510APB manual Copyright Statement, May

Page 2

Copyright Statement

No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, whether electronic, mechanical, photocopying, recording, or otherwise without the prior writing of the publisher.

MAY. 2005

User’s Guide

2

Image 2
Contents User’s Guide Copyright Statement MAYContents Introduction Safety Notification Front Panel Hardware InstallationPower 11a 11g Ethernet Rear Panel Reset Button Ethernet PowerAP Default Settings Hardware Installation for Connection to Your local network How to Configuring the Dual Band AP Turn on Power SupplyStatic IP Setup Network SetupNetwork Setup Wireless Wireless Settings Wireless-A SettingsUser’s Guide Wireless Wireless Mode Wireless MAC Filter Wireless-A SettingSecurity Mode Wireless Wireless SecurityWireless Security WPA onlyWireless-A Settings Authentication Type Wireless Advanced Wireless SettingsAdvanced Wireless Wireless-B/G Settings Authentication Type User’s Guide Administration Management Backup and RestoreAdministration Reboot AP Administration Firmware Upgrade Firmware UpgradeAdministration Factory Defaults Factory DefaultsLocal Area Network Status Local NetworkIdentity Wireless-B/G Settings Status Wireless NetworkWireless Settings Wireless-A Settings Status Wireless Statistics Can’t access the AP from a wireless client. Answer Troubleshooting Q & aHow to set the AP to factory default setting. Answer My AP will not turn on. No LED’s light up AnswerLimited Warranty Federal Communication Commission Interference Statement FCC Radiation Exposure StatementUser’s Guide