TRENDnet TEW-510APB manual Status Wireless Network, Wireless Settings Wireless-A Settings

Page 24

4.12 Status – Wireless Network

The Wireless Network screen on the Status Tab displays the information of your Wireless networks.

Wireless Settings

Wireless-A Settings

MAC Address: This is the AP’s Wireless-A band MAC Address.

Mode: This mode is displaying the current status of Wireless-A band network. Enabled means the A band network is ON.

Turbo Mode: This mode is displaying the turbo mode status. (Enabled/Disabled)

SSID: This displays the AP’s current Wireless-A SSID string.

Broadcast SSID: This displays the AP’s SSID Broadcast status.

Channel: The current A band channel you are using.

Wireless-B/G Settings

MAC Address: This is the AP’s Wireless-G band MAC Address.

Mode: This mode is displaying the current status of Wireless-B/G band network. Enabled means the B/G band network is ON.

Radio Policy: This displays the Wireless-G band network mode.

SSID: This displays the AP’s current Wireless-B/G SSID string.

Broadcast SSID: This displays the AP’s SSID Broadcast status.

Channel: The current G band channel you are using.

User’s Guide

24

Image 24

Contents User’s Guide Copyright Statement MAYContents Introduction Safety Notification Hardware Installation Power 11a 11g EthernetFront Panel Reset Button Ethernet Power AP Default SettingsRear Panel Hardware Installation for Connection to Your local network How to Configuring the Dual Band AP Turn on Power SupplySetup Network Setup Network SetupStatic IP Wireless Wireless Settings Wireless-A SettingsUser’s Guide Wireless Wireless Mode Wireless MAC Filter Wireless-A SettingWireless Wireless Security Wireless SecuritySecurity Mode WPA onlyWireless Advanced Wireless Settings Advanced WirelessWireless-A Settings Authentication Type Wireless-B/G Settings Authentication Type User’s Guide Administration Management Backup and RestoreAdministration Reboot AP Administration Firmware Upgrade Firmware UpgradeAdministration Factory Defaults Factory DefaultsStatus Local Network IdentityLocal Area Network Status Wireless Network Wireless Settings Wireless-A SettingsWireless-B/G Settings Status Wireless Statistics Troubleshooting Q & a How to set the AP to factory default setting. AnswerCan’t access the AP from a wireless client. Answer My AP will not turn on. No LED’s light up AnswerLimited Warranty Federal Communication Commission Interference Statement FCC Radiation Exposure StatementUser’s Guide