20) Panel switch enable/disable:<< ESC | c | 5 n >> |
| |||||
Code | : [1B ] h + [63] h + [35] h + n | * [00≤n≤FF] h | ||||||
Changes the FEED switch valid or invalid. |
| |||||||
* “n” is only valid for LSB(b0) |
|
|
|
| ||||
* “n” bit has a following meanings |
|
|
| |||||
|
|
| b0 |
| Description |
| ||
|
|
| 0 | enable FEED switch |
| |||
|
|
| 1 | disable FEED switch |
| |||
|
| Default value of “n” is [00]h. |
| |||||
21) Print and “n” line feed:<< ESC | d n >> |
|
|
| ||||
Code | : [1B] h + [64] h + n |
|
| * [00≤n≤FF] h | ||||
Prints the data in the print buffer and feeds paper by “n” lines. | ||||||||
* Beginning of a line is a print start position. |
| |||||||
* If there is print data remained, line feed is activated for the same height of character. | ||||||||
22) Character code table select:<< ESC | t | n >> |
| |||||
Code | : [1B] h + [74]h + n |
|
| * [00≤n≤01]h | ||||
Selects either Japan code table or | ||||||||
Explanation | : “n” value has following meaning. |
| ||||||
| n(Hex) |
| character code table |
|
| |||
00
01Japan character code table
The default value of “n” is
23) Printer status transmission :<< ESC v >>
Code : [1B] h + [76] h Sends current printer status
*Status to be transmitted consist of 1 byte and the content is explained in the chart below.
bit | Functions |
| Value | |
0 |
| 1 | ||
|
|
| ||
0 | paper near end | paper present |
| near end |
1 | platen open | normal |
| head open |
2 | paper end | paper present |
| no paper |
3 | head temp. abnormal | normal |
| Temp. high |
4 | cutter problem | normal |
| cutter problem |
5 | presenter problem | normal |
| presenter problem |
6 | paper remove sensor | no paper |
| paper present |
information |
| |||
|
|
|
| |
7 | not defined |
|
|
|
*Make sure that command is issued before transmission of print data. (commands are stored in the input buffer and executed sequentially)
*Reception is available except in the buffer full status.
*The commands above are valid only for serial interface.
*Regarding DTR/DSR control, only one byte is transmitted after confirmation that the host is able to receive data, that is DSR signal is in SPACE status. For XON/OFF
control, one byte is transmitted without confirmation of DSR signal status.
*For DTR/DSR control, if host is not in a receivable status, it waits until host can receive data.
24) Inverted character set and reset | :<< ESC { n >> |
28