Code | : < 1B >h + < 61 >h + n | * < 00≤n≤02 >h | ||
Description | : Aligns all data to be printed on the assigned position in a line. | |||
* “n” values are assigned to: |
| |||
| n (Hex) | Position |
|
|
00Left
01Center
02Right
*This command is valid only when it is input at the head of a line.
*The default value of “n” is [00]h.
39) Total cut (Full cut) | :<< ESC i >> |
* The command functions differently between Standard and Windows models. | |
Code | : < 1B >h + < 69 >h |
[Standard] |
|
*
*Effective at the head of a line
*Feeds paper by 3mm after paper cut to prevent from paper jam. [Windows]
*
*Effective at the head of a line
*Feeds paper by 3mm after paper cut to prevent from paper jam
40) Partial cut | :<< ESC m >> |
* The command functions differently between Standard and Windows models. | |
Code | : < 1B >h + < 6D >h |
[Standard] |
|
*Partially cut paper (with one point left uncut at the center position)
*Effective at the head of a line
*Feeds paper by 3mm after paper cut to prevent from paper jam. [Windows]
*Partially cut paper (with one point left uncut at the center) after feeding paper by 21.25mm.
*Effective at the head of a line.
*Feeds paper by 3mm after paper cut to prevent paper jam.
41) No paper sensor select | :<<ESC c 3 n1 n2>> | |||
Black mark sensor command |
| |||
Code | :<1B>h + <63>h + <33>h + n1 + n2 * < 00≤n1≤01 >h | |||
|
|
|
| * < 00≤n2≤FF >h |
* n1 | = 0, no paper sensor | (thermal paper) | ||
* n1 | = 1, black mark sensor | (label paper) | ||
* Value “n2” is available only at label selection in “n1”.
Feeds paper by dots assigned after label position is confirmed. Minimum amount of paper feed: 0.125mm
Feeds 0.125mm x “n2” amount of paper Default value selects the thermal paper.
Auto loading function is not available at label selection.
33