Xantrex Technology GT3.0 Monitoring the Front Panel Display, 1Front Panel LCD Location

Monitoring the Inverter

Monitoring the Front Panel Display

During startup

During waiting period

During operation

When the inverter is offline or there is fault condition

During startup, the inverter’s front panel LCD (see Figure 5-1) shows the first three screens described in Table 5-1, “Startup Screens on GT Inverter Front Panel Display” on page 5–3.

When the five-minute, five-second (305 seconds) protection timer begins, the inverter displays “Reconnecting in sss seconds” (see Table 5-10, “Special Message Screens” on page 5–8).

When the protection timer stops, the GT Inverter begins selling power, indicated by the power output reading in the display (see Table 5-2, “Normal Operation Default Screen” on page 5–4).

When the GT Inverter is offline (e.g., at night) or a fault condition has been detected, the LCD shows a message screen to indicate that state. The specific fault condition will be identified. See Table 5-5, “Offline Mode Default Display” on page 5–5 and Table 5-8, “Fault Message Screens” on page 5–7.

	Important: The values in the front panel LCD are not user adjustable.
	Front panel LCD	Tap Xantrex logo for
		backlight/status screens.
	Figure 5-1Front Panel LCD Location
Viewing more	Additional screens of information about the performance of the GT Inverter can be
information	displayed by tapping the Xantrex logo on the inverter front panel. This causes the
	LCD to cycle through a series of information screens in Normal Operation,
	Offline or Fault modes. These are described in detail in the following section,
	“Front Panel Display Screens and What They Mean”.

5–2 975-0131-01-01