Fujitsu ST5112, ST5111 Important Safety Instructions, AC Adapter output polarity, System Disposal

Page 4

S t y l i s t i c S T 5 1 0 0 S e r i e s T a b l e t P C - U s e r ’ s G u i d e

IMPORTANT SAFETY INSTRUCTIONS

This unit requires an AC adapter to operate. Use only UL Listed Class 2 Adapters with an output rating of 16 VDC, with a current of 3.75A minimum.

AC Adapter output polarity:

+

When using your tablet PC equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following:

Do not use this product near water for example, near a bathtub, washbowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool.

Avoid using the modem during an electrical storm. There may be a remote risk of electric shock from lightning.

Do not use the modem to report a gas leak in the vicinity of the leak.

Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal instructions.

To reduce the risk of fire, use only No. 26 AWG or larger UL Listed or CSA Certified Telecommunica- tion Line Cord

For TV Tuner Models: To protect from overvoltages and transients on the Cable Distribution System, make sure that the outer shield of the coaxial cable is con- nected to earth (grounded) at the building premises as close to the point of cable entrance as practicable, as required per NEC Article 820.93, ANSI/NFPA 70: 2005. If you have questions about your CATV installa- tion, contact your service provider.

SAVE THESE INSTRUCTIONS

For Authorized Repair Technicians Only

Danger of explosion if Lithium (clock) bat- tery is incorrectly replaced. Replace only with the same or equivalent type recom- mended by the manufacturer. Dispose of used batteries according to the manufac- turer’s instruction.

For continued protection against risk of fire, replace only with the same type and rating fuse.

System Disposal

LAMP(S) INSIDE THIS PRODUCT Hg CONTAIN MERCURY AND MUST BE RECYCLED OR DISPOSED OF

ACCORDING TO LOCAL, STATE, OR FEDERAL LAWS.

Image 4
Contents User’s Guide Page Copyright and Trademark Information OmniPass is a trademark of Softex, IncImportant Safety Instructions AC Adapter output polarityFor Authorized Repair Technicians Only System DisposalTable of Contents Appendix B Security Device USER’S Guide Preface Page Limited Warranty Information PrefaceAbout this Guide Fujitsu Contact InformationPage Getting Started with Your Tablet PC Page Optional Accessories Getting Started with Your Stylistic Tablet PCStylistic Tablet PC Features Infrared keyboard/mouse ports The infrared portsBack Features Top Features Left-Side Features Right-Side Features Status Display Icon Mode/State LED State RemarksSystem Status Indicators Application Buttons Control Panel -Tablet Button Settings Tablet Button SettingsMenu UtilityNavigation Buttons Navigation ButtonsTertiary Functions of Application and Navigation Buttons Same as if you had tapped F2 on a keyboardPasswords Setting UP the Security PanelSecurity Functions of Application Buttons Using Your Security Panel PrecautionsUninstalling the Security Panel Application Fujitsu Driver Update Utility Reinstalling the Security Panel ApplicationRecommend that you install the ClickMe! utility the first UserConnectors and Peripheral Interfaces Connector Tablet PC Purpose PeripheralPeripheral Connectors/Interfaces Page Using Your Stylistic Tablet PC Page Using the Stylistic ST5100 Series Tablet PC System StatesPowering UP the Tablet PC Booting the System the First TimeStarting Windows Vista the first time Registering Windows Vista with MicrosoftShutting Down the System Suspending System OperationRegistering Your Stylistic Tablet PC with Fujitsu Registering Windows XP with MicrosoftPower icon is blinking Standby mode Power icon is not displayed Hibernate modeFrom Standby mode From Hibernate modeUsing the Shock Sensor Utility Adjusting the Display BrightnessUsing the PEN Tip Switch Pen Tether Attachment PointInstalling a PEN Tether Charging the BatteryCalibrating the PEN Replacing the PEN TIPRemoving and Installing the Battery Tips for Conserving Battery PowerBattery uses Lithium ion battery cells which have Operation of the Bridge BatteryMemory STICK/SD Card Slot Modem ConnectionPC Card Slot Removing and Installing Memory Installing a Memory ModuleTo install a Dimm module in the Tablet PC Removing a PC CardInstalling a Dimm Module Removing a Memory ModulePage Care and Maintenance Page Caring for Your Tablet PC Care and MaintenanceProtecting the Display Screen Storing the Tablet PC Avoiding OverheatingCleaning the Display Screen TroubleshootingRestoring the PRE-INSTALLED Software Configuring Peripheral InterfacesRe-Installing Individual Drivers and Applications Boot Priority ChangeAutomatically Downloading Driver Updates ProcedureCheck for updates now About Fujitsu Driver UpdatePage System Specifications Page Stylistic ST5100 Series Hardware Specifications Processing SpecificationsPower Specifications Regulatory Information FCC NoticesAvis Aux Utilisateurs Du Réseau Téléphonique Canadien Appendix a Page FCC Regulatory Information Before Using the Wireless LAN Wireless LAN Devices Covered by this DocumentCharacteristics of the Wlan Device Wireless LAN Modes Using this Wireless ModuleHow to Handle This Wireless Module Deactivation using the wireless switchDeactivation using Windows Stopping TransmissionAtheros Wireless LAN Starting TransmissionConnecting the Wlan Configuring the Wlan With Windows VistaConfiguring the Wlan Using Windows XP Connecting to a Network with Windows VistaConfiguring Using Atheros Client Utility Software Field Name DescriptionSetting TCP/IP Setting the networkConnection to the Network Setting the sharing function Setting the Microsoft network-sharing serviceSetting the file-sharing function Confirming the computer and work group namesSetting the printer-sharing function Confirming connectionConfirming the status of the radio Network Name SsidMode SecuritySpeed Band FrequencyTroubleshooting UnavailableNetwork ConnectionAccess point CommunicationIs disconnected Soon afterWireless LAN Glossary Open system authentication Shared key authenticationSsid Service Set Identifier Wi-FiIP address information Specifications SpecificationsUsing the Bluetooth Device What is BLUETOOTH?Where to Find Information about Bluetooth WarrantyPage Appendix B Page Installing Omnipass Installing the OmniPass ApplicationIntroducing Fingerprint Sensor Device Getting StartedUninstalling OmniPass Master Password ConceptUser Enrollment Verifying Information about OmniPassUsing Omnipass Password ReplacementOmniPass Authentication Toolbar Basic EnrollmentRemembering a Password Logging in to a Remembered SiteConfiguring Omnipass Password ManagementIdentities and Password Management OmniPass User IdentitiesOmnipass Control Center Exporting an OmniPass User ProfileImporting an OmniPass User Profile Things to Know Regarding Import/ExportUser Settings System SettingsCannot add a User with a Blank Password to OmniPass First option, Automatically log on to OmniPass asTrusted Platform Module Installation Installing the TPM ApplicationsProcedure Enabling the Security Chip in BiosBattery power Adjusting the display brightness Air flow ventsIndex Pen tether Peripheral connectors Setting up Security Panel Shock Sensor UtilityStylistic ST5000 specifications Microphone jackWireless LAN/Bluetooth on/off switch USB ports Using the penTurning off the system Y l i s t i c S T 5 1 0 0 S e r i e s T a b l e t P C Page Page