Fujitsu ST4000P Resuming System Operation, Using the PEN, Installing a PEN Tether, U T I O N S

S t y l i s t i c S T 4 0 0 0 P S e r i e s U s e r ’ s G u i d e – S e c t i o n T w o

may be logged off the network after a period of inactivity while system operation is suspended. Contact your network administrator or help desk for details on log-off parameters for your network.

RESUMING SYSTEM OPERATION

To resume system operation from either Suspend-to- RAM or Hibernate modes, press the Suspend/Resume button.

•From Suspend-to-RAM mode

Status lights indicate that the system state is changing. It may take up to a minute before the system returns to the On state and system operation resumes. Note that the display turns on shortly before the pen becomes active due to the power-up sequences observed by the system.

•From Hibernate (Save-to-Disk) mode

Active data is read from the hard disk drive, and the system returns to the On state after a short time.

P O I N T

Note that power to several system components must be restored before system operation resumes. Allow sufficient time for system operation to resume before attempting to use the system. If your system uses Hibernate mode, it will take longer to resume operation as compared to using Suspend-to-RAM mode. Time is needed to read data from the hard disk drive.

•Use the system as you normally would once system operation resumes.

All programs resume at the point where execution stopped when system operation was suspended.

USING THE PEN

You can use the Stylistic ST4000P Series pen to select items, and to navigate through programs on the pen tablet PC. The pen can be used like a two button mouse when used in conjunction with the right-mouse button.

C A U T I O N S

•Ensure that a screen protector is installed on the pen tablet PC screen before you use the pen. The warranty does not cover a screen that is scratched as a result of not using a screen protector.

•Use only the pen provided with your pen tablet PC. Do not use substitutes that were not designed for the Stylistic ST4000P Series pen tablet PC. (e.g., ball point pens, fingernail, or screwdriver). Damage caused by using an instrument other than the provided pen is not covered by the system warranty.

Here are some hints on using the pen similar to a two- button mouse on a desktop system:

•To select an object, tap the pen tip on the object once. This functions like a left mouse button click.

•To “double-click” an object, tap twice on the object quickly. (The pen double-click speed is in sync with the mouse double-click speed, and can be changed by going to Start-> Settings -> Control Panel -> Mouse.

•To generate a “right mouse button single-click”,

press the Right-Click Application Button , then tap on the object once.

•To move, or “drag”, an object on the screen, place the pen tip directly over the object, then as you hold the pen tip against the screen, move the pen.

INSTALLING A PEN TETHER

To prevent dropping or losing your pen, you should attach it to your system using the pen tether that is included with the system.

To attach the pen tether to your Tablet PC, perform the following steps:

1.Attach the end of the pen tether with the smaller loop to your pen. Do do so, push the end of the tether through the hole in the pen, then thread the opposite end of the tether through the loop. (See Figure 2-1)

Pen tether attachment point

Larger loop

Smaller loop

Figure 2-1 Installing a Pen Tether

2.Attach the end of the pen tether with the larger loop to the attachment point on your pen tablet. To do so, insert the end of the pen tether through the attach- ment point, then feed the pen through the large loop in the tether.

22