Fujitsu Stylistic ST4000P Specifications, Physical Specifications, Processing Specifications

Page 45

S y s t e m S p e c i f i c a t i o n s

Stylistic ST4000P Series Hardware Specifications

The following table provides general hardware specifications of the Stylistic ST4000P Series pen tablet PC by category.

	Stylistic ST4000P Specifications

		Physical Specifications

Dimensions		11.86” w x 8.66” d x 0.82”-0.88” h
		(301.3mm x 220mm x 20.9-22.3mm)

Weight		3.2 lbs. (1.45 Kg)

		Processing Specifications

CPU		Ultra low voltage Mobile Intel Pentium
		III processor - M with SpeedStep
		technology*

Chip set		Intel 830MG - 133 MHz

Processor		800 MHz*
Speed

	Memory/Storage Specifications

Main RAM		• 256MB SDRAM (on-board/
			PC133).
		•	144-pin SO DIMM modules
		256MB and 512MB module
		configurations available, with a system
		maximum of 768MB.

L1 cache		32 KB on-die
(CPU)

L2 cache		512 KB on-die

BIOS ROM		8 Mbit (FWH)

Hard disk		•	2.5” HDD
drive		•	Minimum 20GB IDE HDD*
		•	Ultra DMA 100
		•	Shock-mounted

Stylistic ST4000P Specifications (Continued)

Display Specifications

Display	•	Color LCD
	•	Passive Touch Panel
	•	16-bit color
	• 10.4” TFT XGA (1024 x 768), 260K
		colors
	•	Brightness: 8 levels
	•	Viewing Angle:
		Horizontal: 30 degrees (min.)
		Vertical: 10 degrees (min.)
	•	Contrast Ratio:
		Typ. 250, Min. 100

VRAM	Intel 830MG chipset with 8MB shared
	memory using Unified Memory
	Architecture (UMA) delivers low-
	power, high-performance 3D/2D
	graphics, video, and display capabilities.
	Dynamic Video Memory Technology
	(DVMT) dynamically responds to
	application requirements and efficiently
	allocates the proper amount of memory
	(48MB max.) for optimal graphics and
	system performance.

	Interface Specifications

PC Card	•	One Type I or Type II
Slots	•	PCMCIA CardBus version 3.0

Integrated	•	Modem (RJ-11)
Interfaces	•	LAN (RJ-45)
	• IEEE 1394 (S400 4-pin)
	•	USB (Qty. 2)
	•	DC-In
	• 15-pin D-SUB connector for
		external VGA monitor
	•	Docking connector

Infrared	IrDA version 1.1 (FIR, 4Mbps)

35

Image 45

Contents Fujitsu PC Corporation According to FCC PartPage Table of Contents Page Preface Page Warranty Information About this GuideFujitsu Contact Information Page Getting Started with Your Pen Tablet PC Page IN-BOX Items for the Stylistic ST4000P Series PEN Tablet PC Getting Started with Your Stylistic Pen Tablet PCOptional Accessories Front Features Stylistic PEN Tablet PC FeaturesBack Features Top Features Left-Side Features Right-Side Features Icon Mode/State LED State Remarks Status DisplayMode AccessApplication Buttons Tablet Button SettingsTablet Icon DescriptionApplication Buttons Primary and Secondary Functions Navigation Buttons Tertiary Functions of Application and Navigation Buttons Connector Pen Tablet Purpose Peripheral Connectors and Peripheral InterfacesPeripheral Connectors/Interfaces Page Using Your Stylistic ST4000P Series Pen Tablet PC Page System States Using the Stylistic ST4000P Series Pen Tablet PCShutting Down the System Powering UP the PEN Tablet PCSuspending System Operation Current State To Change StatePower icon is blinking Suspend-to-RAMmode Power icon is not displayed Hibernate modeU T I O N Installing a PEN Tether Using the PENResuming System Operation U T I O N SCharging the Battery Using Hovering ModeCalibrating the PEN To Calibrate the PenRemoving and Installing Battery Tips for Conserving Battery PowerI N T Removing and Installing Memory Modules Modem ConnectionPC Card Slot Removing a Memory Module Installing a Memory ModuleCare and Maintenance Page Protecting the Display Screen Care and MaintenanceTroubleshooting Cleaning the Display ScreenStoring the PEN Tablet PC Avoiding OverheatingSpeaker/Headphone Volume Too Low Configuring Peripheral InterfacesPen Tablet PC is Not Responding to the Pen Page Specifications Page Physical Specifications Stylistic ST4000P SpecificationsProcessing Specifications Memory/Storage SpecificationsEnvironmental Specifications Power SpecificationsAgency Approval Specifications Additional SpecificationsAgency Notices Page FCC Registration Number Regulatory InformationE R T I S S E M E N T Avis Aux Utilisateurs Du Réseau Téléphonique CanadienFor Authorized Repair Technicians Only UL NoticeR N I N G S System DisposalPage Appendix Page Regulatory Notes and Statements FCC Regulatory InformationFederal Communications Commission statement FCC Interference StatementCharacteristics of the Device Before Using this DeviceWireless LAN Modes Using this Device How to Handle This DeviceSetting Parameters Connecting Windows 2000 SystemsWhen you finish your entry, click Apply WorkflowTCP/IP Settings Network SettingsEncryption Key Setup Network Connection WindowsSetting File and Printer Sharing for Microsoft Networks Checking the full computer name and workgroupSharing Sharing Files Accessing Another ComputerPrinter Sharing Checking the ConnectionChecking connectivity Connecting Windows XP SystemsOn Wireless Network Connection Properties, click General Network SettingsNetwork Connection Click OKSharing Setting computer name and workgroupTransfer data for send Tx and receive Troubleshooting Table Windows XP Click Start All Programs Accessories Windows 2000 Click Start Programs AccessoriesYou want to store the IP address Click Enter, then go to the location you specified above.Windows Problem Possible CauseSetting IP Addresses Problem Possible Cause Possible SolutionAbout IP Addresses Windows XPTechnical Specifications for Integrated Wireless LAN Device SpecificationsPage Battery power Battery gauge Battery gauge icon Battery icon Battery packBattery release button Battery release latch External Monitor ConnectorPower On/Suspend/Resume Button Power usage Peripheral connectorsOverheating, avoiding Save-to-Disk mode Solving problems Speaker Speaker/headphone volume too lowSystem interface connector Stylistic ST4000P SpecificationsWireless LAN module Wireless LAN On/Off switch Network ConnectionY l i s t i c S T 4 0 0 0 P S e r i e s