Fujitsu D1561 Pin assignment of internal ports, Front panel, Power On LED, Serial ATA internal

Pin assignment of internal ports

Pin assignment of internal ports

The pin assignment of some internal connections is shown in English in the following.

i Some of the following connectors may be optional!

Front panel

Watch the poling of the LEDs. The positive pole of the connection cables is often indicated with a coloured wire.

Power On/Off Message LED Sleep LED

	Power On
HD-LED	LED 2)
Reset
		1
	2

SCSI LED Input 1)

1)The same interface

2)2pin or 3pin connector possible

Connection	Note
Reset
Power On/Off
HD LED
SCSI Activity	Attention: Do not connect to the LED connections of an SCSI controller! This
Input	connection is intended for a cable with a 4-pin connector. An SCSI controller
	reports activity (low-active) via this cable.
Message LED
Power On LED	Indicates the system state APM or ACPI together with the Sleep LED (see
	chapter entitled "APM and ACPI system status, energy-saving modes").
Speaker	0,5 W at 8 Ohm
Sleep LED	Indicates the system state APM or ACPI together with the Power-On LED (see
	chapter entitled "APM and ACPI system status, energy-saving modes").

Power On LED II

1 3

Pin

1

2

3

Signal

Power On LED (Anode)

Power On LED (Anode)

Power On LED (Cathode)

Serial ATA (internal)

1

10 - English A26361-D1562-Z120-2-6319