IBM PC 300GL manual Input/output address map, O address map Address hex Size Description, LPT3

Input/output address map

The following lists resource assignments for the I/O address map. Any addresses that are not shown are reserved.

Table 33. I/O address map

Address (hex)	Size	Description
0000–000F	16 bytes	DMA 1
0010–001F	16 bytes	General I/O locations - available to PCI bus
0020–0021	2 bytes	Interrupt controller 1
0023–003F	30 bytes	General I/O locations - available to PCI bus
0040–0043	4 bytes	Counter/timer 1
0044–00FF	28 bytes	General I/O locations - available to PCI bus
0060	1 byte	Keyboard controller byte - reset IRQ
0061	1 byte	System port B
0064	1 byte	Keyboard controller, CMB/STAT byte
0070, bit 7	1 bit	Enable NMI
0070, bits 6:0	1 bit	Real-time clock, address
0071	1 byte	Real-time clock, data
0072–007F	14 bytes	General I/O locations - available to PCI bus
0080	1 byte	POST checkpoint register during POST only
008F	1 byte	Refresh page register
0080–008F	16 bytes	ICH1, DMA page registers
0090–0091	15 bytes	General I/O locations - available to PCI bus
0092	1 byte	PS/2 keyboard controller registers
0093–009F	15 bytes	General I/O locations
00A0–00A1	2 bytes	Interrupt controller 2
00A2–00BF	30 bytes	APM control
00C0–00DF	31 bytes	DMA 2
00E0–00EF	16 bytes	General I/O locations - available to PCI bus
00F0	1 byte	Coprocessor error register
00F1–016F	127 bytes	General I/O locations - available to PCI bus
0170–0177	8 bytes	Secondary IDE channel
01F0–01F7	8 bytes	Primary IDE channel
0200–0207	8 bytes	Available
0220–0227	8 bytes	Serial port 3 or 4
0228–0277	80 bytes	General I/O locations - available to PCI bus
0278–027F	8 bytes	LPT3

48PC 300 GL and 300 PL