Fujitsu MAX3147RC, MAX3036RC, MAX3073RC manual Important Alert Items, Important Alert Messages

Important Alert Items

Important Alert Messages

The important alert messages in this manual are as follows:

A hazardous situation could result in minor or moderate personal injury if the user does not perform the procedure correctly. Also, damage to the product or other property, may occur if the user does not perform the procedure correctly.

Task		Alert message	Page
Installation	Damage
	Never remove any labels from the drive or deface them in any way.		4-3
	High temperature
	To prevent injury, never touch the drive while it is hot. The DE and LSI		5-1, 5-10
	become hot during operation and remain hot immediately after turning off
	the power.
	Damage
	1. When dismounting the drive which is mounted on the		5-10
	system while power is supplied to it.
	•	The spindle motor can be stopped by a START/STOP command. It
		takes about 30 seconds for the spindle motor to stop completely.
	•	Then, dismount the drive using the drive mounting/dismounting
		mechanism, etc. of the system. If the drive is dismounted while the
		spindle motor is running, special care is required to avoid excessive
		vibration or shock to the drive. Just in case, stop dismounting once
		when SAS connector breaks off contact and wait until the spindle
		motor stops (about 30 seconds.).
	•	When storing or transporting the drive, put it in the antistatic bag
		(refer to Section 5.1).

C141-E237 iii