Fujitsu M3097DE, M3097DG manual Removing the Carrier Fixing Bracket

Page 27

Removing the Carrier Fixing Bracket

To keep the scanner from being damaged during shipping, the carrier unit is fixed with a bracket. After placing the carrier unit at the installation place, remove this bracket as explained below.

qPlace the image scanner on the edge of the desk top so that the left side (where ADF is placed) of the scanner extends from the desk top. Do not set the image scanner upside down or on its side.

CAUTION

Do not extend the scanner more than 20cm (8 in.) from the desk.

Good Bad Bad

less than 20cm (8 in.)

wRemove the carrier fixing bracket from position A. Then install the carrier fixing bracket at position

B.

Front side

Bottom view
Carier bracket (Position for
storage, position for shipment)
Enlarged section A enlarged	ADF side
	ADF side

Enlarged

Carier fixing bracket (Position for operation)

B

A

Carier bracket (Position for shipment)

2-4

Image 27

Contents M3097DE/DG Image Scanner M3097DE/DG Image Scanner Page Fujitsu Australia Limited Important Note to Users Preface TION, Operating INSTRUCTION,DOCUMENT SpecificationConventions Page Contents Viii Terms Components Cheking the Components Units Units and AssembliesFunction Assemblies Arrangement Operator PanelName of the button Function LED Button/LED FunctionCounter Function Counter DisplayOperation status Temporary error Alarm Installation and Connections Precautions C I a InspectionFujitsu Limited Removing the Carrier Fixing Bracket Turning the power switch off Connecting the power cableCable Connection M3097DE Connecting the interface cableMounting the Stacker SCSI-ID setting M3097DG Operating Instruction Turning the Power On Reading Mode Setting M3097DE Without IPC With IPC-2D Descreption Option Or IPC-3D option AT1AT2 LP1 Parameter DescriptionHT1 HT2Parameter Description Manual Feed Mode Setting ADF Document Specification Scanner Maximum Minimum M3097DE/DG Document SizeDocument type Paper weightPrecautions Document QualityPage Page Specifications Specification Installation SpecificationsDimensions Consumables Name Specification RemarkTBD OptionSetup Mode Activating the Setup Mode Contents of the Setup Mode Setting double feed detection Setting IPC pre-set mode DTC Setting pick start time Reset of abrasion counterSetting Offset Setting time-out limitPage Reviewing the IPC/Memory Status Setting SCSI-ID M3097DGPage Glossary of Terms Double feed detection Duplex reading modeEquipment Error Error diffusionImage processing IPC pre-set modeHexadecimal Image emphasisLetter size Linedrawing modeManual Feed mode = Manual Mode Manual start mode automatic start modePortrait Photograph mode White level follower OFFPhoto mode = photograph mode Pick start timeSmoothing Setup modeSimplex reading mode Temporary ErrorIndex ADFIPC SCSI-ID Page IN-4