Fujitsu M3097DE, M3097DG manual Contents of the Setup Mode

Contents of the Setup Mode

This section describes the contents of the setup mode.

No	Item	Description	Selectable	Default
			parameters
1	Double feed check	Double feed is detected by checking the	Tolerance:	No
		document length one by one.**	No/10/15/20mm
2	IPC pre-setting	Scanner automatically sets the recom-	Document:	No
		mended reading parameters. 5 sets of	No/1/2/3/4/5
		recommended parameters are available.
3	Rest of abrasion	Abrasion counter can be reset.	-	-
	counter
4	Pick start time	The time from the document Insertion to	Time:
	setting	the start of picking is specified. User can	0.2 to 29.8 sec	1.0 sec
		select most comfortable Pick start time for
		the job.
5	Time-out limit setting	The time that the scanner waits for next	Time:
		ducument insertion after last document	27 values from	30 sec
		scanned can be specified.	1 to 1999 sec
6	ADF front offset	Horizontal and vertical offset of the front	Offset:	Offset:
	setting*	side image by ADF is specified.	H:-2 to +3mm	H: 0 mm
			V:-2 to +3mm	V: 0 mm
7	ADF back offset	Horizontal and vertical offset of the back	Offset:	Offset:
	setting*	side image by ADF is specified.	H:-2 to +3mm	H: 0 mm
			V:-2 to +3mm	V: 0 mm
8	FB offset setting*	Horizontal and vertical offset of the FB	Offset:	Offset:
		image is specified.	H:-2 to +3mm	H: 0 mm
			V:-2 to +3mm	V: 0 mm
9	IPC/Memory status	The type of IPC option (IPC-2D or IPC-3D)
	display	and total memory installed are displayed.
10	SCSI ID setting	SCSI ID is selectable.	SCSI ID:
			0/1/2/3/4/5/6/7	5

*This offset means the deference from the value adjusted by automatic offset adjustment.

**The document length on ADF paper chute must be same. If the completely overlapped sheets are fed, the scanner cannot detects the double feed.

6-2