Fujitsu M3097DE, M3097DG manual Document Quality, Document type, Paper weight, Precautions

Page 41

Document Quality

This section describes document types and weights available for the scanner, and precautions.

Document type

The recommended paper type for document is as follows:

Woodfree paper

Plain paper (for example, the paper specified for XEROX 4024)

When using all other type paper, check that it is successfully fed by ADF before performing a reading operation.

Paper weight

The paper weight is as follows :

• 52 to 104 g/m2 (3.9 to 27.8 lb)

Precautions

The following documents may be hard to read by ADF. Preliminary document feed test may be necessary to avoid the unexpected errors. If the document slips in ADF (JAM error) or double feed occurs frequently, read them by flatbed.

Paper with clips or staple

Paper with wet ink

Paper of which thickness is not constantly equal. (like envelope)

Paper with large rumples or curl. (See NOTE on the next page.)

Paper with folds or tears

Tracing paper

Coating paper

Carbon paper

Paper smaller than 148 mm x 105 mm size, or larger than A3 or Double Letter

Other than paper ; clothes, metal foil, or OHP film

Photographic paper

Paper with notches on its side

Other than rectangle paper

Paper that is very thin

4-2

Image 41
Contents M3097DE/DG Image Scanner M3097DE/DG Image Scanner Page Fujitsu Australia Limited Important Note to Users Preface TION, Operating INSTRUCTION,DOCUMENT SpecificationConventions Page Contents Viii Terms Components Cheking the Components Units Units and AssembliesFunction Assemblies Arrangement Operator PanelName of the button Function LED Button/LED FunctionCounter Function Counter DisplayOperation status Temporary error Alarm Installation and Connections Precautions C I a InspectionFujitsu Limited Removing the Carrier Fixing Bracket Cable Connection Turning the power switch offConnecting the power cable M3097DE Connecting the interface cableMounting the Stacker SCSI-ID setting M3097DG Operating Instruction Turning the Power On Reading Mode Setting M3097DE AT2 Without IPC With IPC-2D Descreption Option Or IPC-3D optionAT1 HT1 Parameter DescriptionHT2 LP1Parameter Description Manual Feed Mode Setting ADF Document Specification Scanner Maximum Minimum M3097DE/DG Document SizePrecautions Paper weightDocument Quality Document typePage Page Specifications Specification Installation SpecificationsDimensions Consumables Name Specification RemarkTBD OptionSetup Mode Activating the Setup Mode Contents of the Setup Mode Setting double feed detection Setting IPC pre-set mode DTC Setting pick start time Reset of abrasion counterSetting Offset Setting time-out limitPage Reviewing the IPC/Memory Status Setting SCSI-ID M3097DGPage Glossary of Terms Equipment Error Duplex reading modeError diffusion Double feed detectionHexadecimal IPC pre-set modeImage emphasis Image processingManual Feed mode = Manual Mode Linedrawing modeManual start mode automatic start mode Letter sizePhoto mode = photograph mode Photograph mode White level follower OFFPick start time PortraitSimplex reading mode Setup modeTemporary Error SmoothingIPC IndexADF SCSI-ID Page IN-4