Fujitsu M3097DE, M3097DG manual

Page 3

Edition

Date published

Revised contents

01

December, 1997

First edition

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Specification No. C150-E101-01EN

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

This digital apparatus does not exceed the Class A limit for radio noise emissions from digital apparatus set out in the Radio interference Regulations of the Canadian Department of Communications.

Le pésent appareil numérique n’ément pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe A prescridtes dans le Réglesment sur le brouillage radioélectrique dicté par le ministere des Communi- cations du Canada.

MaschinenlärmInformationsverordnung 3. GSGV, 18.01.1991:Der arbeisplatzbe- zogene Schalldruckpegel beträgt 70dB(A)oder weniger gemäß ISO 7779.

The contents of this manual may be revised without prior notice.

All Rights Reserved, Copyright © 1997 FUJITSU LIMITED. Printed in Japan.

No part of this manual may be reproduced in any form without permission.

i

Image 3
Contents M3097DE/DG Image Scanner M3097DE/DG Image Scanner Page Fujitsu Australia Limited Important Note to Users Preface TION, Operating INSTRUCTION,DOCUMENT SpecificationConventions Page Contents Viii Terms Components Cheking the Components Units Units and AssembliesFunction Assemblies Arrangement Operator PanelName of the button Function LED Button/LED FunctionCounter Function Counter DisplayOperation status Temporary error Alarm Installation and Connections Precautions C I a InspectionFujitsu Limited Removing the Carrier Fixing Bracket Turning the power switch off Connecting the power cableCable Connection M3097DE Connecting the interface cableMounting the Stacker SCSI-ID setting M3097DG Operating Instruction Turning the Power On Reading Mode Setting M3097DE Without IPC With IPC-2D Descreption Option Or IPC-3D option AT1AT2 LP1 Parameter DescriptionHT1 HT2Parameter Description Manual Feed Mode Setting ADF Document Specification Scanner Maximum Minimum M3097DE/DG Document SizeDocument type Paper weightPrecautions Document QualityPage Page Specifications Specification Installation SpecificationsDimensions Consumables Name Specification RemarkTBD OptionSetup Mode Activating the Setup Mode Contents of the Setup Mode Setting double feed detection Setting IPC pre-set mode DTC Setting pick start time Reset of abrasion counterSetting Offset Setting time-out limitPage Reviewing the IPC/Memory Status Setting SCSI-ID M3097DGPage Glossary of Terms Double feed detection Duplex reading modeEquipment Error Error diffusionImage processing IPC pre-set modeHexadecimal Image emphasisLetter size Linedrawing modeManual Feed mode = Manual Mode Manual start mode automatic start modePortrait Photograph mode White level follower OFFPhoto mode = photograph mode Pick start timeSmoothing Setup modeSimplex reading mode Temporary ErrorIndex ADFIPC SCSI-ID Page IN-4