2. Bus adapter (if used)
If the screen is not rolling, run the monitor
1.
2.Disconnect the monitor signal cable.
3.
4. Set the contrast to its maximum position.
5.Set the brightness control to the center detent position.
Check the | following | conditions: |
|
|
|
| ||||
The screen contrast and brightness control are | ||||||||||
adjustable. |
|
|
|
|
|
|
| |||
The | screen | is | either | white | or | light | gray, with a black | |||
margin | (test margin). |
|
|
|
|
| ||||
The | screen | is | CRTset ortoboth | on | the | ThinkPad | ||||
Configration |
| program. |
|
|
|
|
| |||
Note: |
| The | location of | the | test | margin | may vary with | |||
|
| the | type | of monitor. It can be either at the top | ||||||
|
| and/or bottom, or left and/or right of the | ||||||||
|
| screen. |
|
|
|
|
|
|
If | you do | not see a test margin on the screen, | replace the |
monitor. If | there is a test margin on the screen, | replace | |
the | system | board. |
|
ThinkPad 380Z 19