Symptom-to-FRU Index
The | the | symptoms | and | errors | |
and | the possible causes. The | most | likely | cause | is listed |
first. |
|
|
|
|
Note: Perform the FRU replacement or actions in the sequence shown in the “FRU/Action” columns. If a FRU replacement did not solve the problem, put the original part back in the computer. Do not replace a nondefective FRU.
This index can also help you determine the next possible FRUs to be replaced when servicing a computer.
Numeric error codes show the errors detected in POST or system operation. In the following Xerrorcan codes,be
any number.
If no codes are available, use narrative symptoms.
If the symptom is not listed, go to “Undetermined Problems” on page 32.
Note: For IBM devices not supported by | diagnostic | ||
codes in | the | ThinkPad notebook computers, | |
see the | manual | for that device. | |
|
|
|
|
Numeric | Error | Codes |
|
Symptom | / Error | FRU / | Action in Sequence |
|
|
|
|
10X |
| System | board |
101:Interrupt failure.
102:Timer failure.
103:Timer interrupt failure.
104:Protected mode failure.
105:Last 8042
command not accepted.
107:NMI test failure.
108:Timer bus test failure.
109:Low
select test.
110 | 1. Go | to | “Memory |
(Planar parity.) | Checkout” | on | |
| page | 12. |
2.DIMM
3.Detach the expansion
unit if it is attached to the computer.
4. System board
ThinkPad 380Z 23