When Both Power-on Password and Supervisor
Password are Set.
1.Power off the computer.
2.Press and holdF1; then power on the computer. After a few seconds, the password prompt appears.
3. | Enter | yoursupervisor | password | . The | |
| |||||
4. | SelectPassword |
| and thenPower | on . A | |
| rectangular | box appears. | |||
5. | Enter | yoursupervisor | password | and press the | |
| Space bar | once. |
|
| |
6. | PressEnter | twice. |
|
7.SelectExit .
8.SelectRestart on the
and wait until the POST ends.
9.Reinstall the
Verify that the password prompt does not appear.
To reactivate the password, set the password again.
Reset Switch: The Reset switch resets the system
regardless of the microcode status and forces a power off. Use this push button to power off when power is not completely off or when the microcode is in a hung state.
ThinkPad 380Z 7