Cisco Systems WS-F6K-PFC3BXL= Applying the Label to the Supervisor Engine, Console show module

Applying the Label to the Supervisor Engine

Step 10 Depending on the software running on the switch, do one of the following steps to verify the installation:

•Cisco IOS software on the supervisor engine and the MSFC3

Verify that the switch is online. This indicates that the system acknowledges the new module and has brought it online.

•Catalyst supervisor engine software on the supervisor engine and Cisco IOS software on the MSFC3

Enter the show module command to verify that the system acknowledges the new module and has brought it online.

This example shows the output of the show module command:

Console> show module
Mod	Slot Ports		Module-Type	Model	Sub	Status
---	---- -----		-------------------------	-------------------	---	--------
1	1	48	10/100BaseTX Ethernet	WS-X6248-RJ-45	no	ok
5	5	2	1000BaseX Supervisor	WS-SUP720-BASE	yes	ok
15	5	1	Multilayer Switch Feature	WS-SUP720	no	ok

...
Mod	Sub-Type	Sub-Model	Sub-Serial	Sub-Hw Sub-Sw
---	-----------------------	-------------------	-----------	------ ------
5	L3 Switching Engine III	WS-F6K-PFC3BXL	SAD073702HH	0.250

Console>

If the installation is not successful, see the “Troubleshooting” section on page 13 for troubleshooting information.

Applying the Label to the Supervisor Engine

The WS-F6K-PFC3B= and WS-F6K-PFC3BXL= kits include a packet of labels. Apply the “PFC3B” or “PFC3BXL” label to the upper-left corner of the Supervisor Engine 720 front panel. (See Figure 7.)

Figure 7 Applying the Label

Apply label here

105886

Catalyst 6500 Series PFC3B and PFC3BXL Installation Note

12 78-16220-02