Cisco Systems WS-F6K-PFC3B=, WS-F6K-PFC3BXL= manual Male Standoff Location on the Supervisor Engine

Page 9

Installing the PFC3B

Figure 4 Male Standoff Location on the Supervisor Engine 720

Male standoffs

105310

Caution Ensure that the PFC3B is securely seated before you install and tighten the cap nut and the securing screws. If you use the screws to seat the PFC3B, the card might warp.

Caution Use care not to damage the connectors on the supervisor engine. If you damage a connector, you will have to return the supervisor engine to Cisco for repair.

Step 4 Using your thumbs, apply pressure at the locations shown in Figure 5 to ensure that the PFC3B is securely seated on the Supervisor Engine 720.

Catalyst 6500 Series PFC3B and PFC3BXL Installation Note

 

78-16220-02

9

 

 

 

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Catalyst 6500 Series PFC3B and PFC3BXL Installation Note Safety Overview ContentsRequired Tools Parts ListInstallation Guidelines Removing the PFC3A from the Supervisor Engine Preparing the Supervisor EngineRemoving Securing Screws and Cap Nuts Removing the PFC3A Installing the PFC3BInserting the PFC3B Under the EMI Gasket Male Standoff Location on the Supervisor Engine Seating the PFC3B on the Supervisor Engine Installing the Supplied Screws Console show module Applying the Label to the Supervisor EngineTroubleshooting Related DocumentationObtaining Documentation Obtaining Technical Assistance Documentation FeedbackCisco Technical Support Website Obtaining Additional Publications and Information 78-16220-02 Obtaining Additional Publications and Information
Top Page Image Contents