Cisco Systems DGS-1224T manual

Page 55

QuietPeriod: Sets the number of seconds that the switch remains in the quiet state following a failed authentication exchange with the client. Default 80 seconds

SuppTimeout: Sets the switch-to-client retransmission time for the EAP-request frame. Default is 12 seconds.

ServerTimeout: Sets the amount of time the switch waits for a response from the client before resending the response to the authentication server. Default is 16 seconds.

MaxReq: This parameter specifies the maximum number of times that the switch retransmits an EAP Request packet to the client before it times out the authentication session. Default is 5 times.

ReAuthPeriod: This command affects the behavior of the switch only if periodic re-authentication is enabled. Default is 3600.

To establish 802.1X port-specific assignments, select the From and To Ports and select Enable.

51

Image 55

Contents Building Networks for People LinkDGS-1224TTable of Contents Page Page Terms/Usage PurposeIntroduction Gigabit Ethernet TechnologyFast Ethernet Technology Ieee 802.1Q Vlan Switching TechnologyIEEE802.1Q Vlan FeaturesTechnical Specifications Ieee 802.3 compliance Flash MemoryPhysical & Environment Temperature Storage TemperaturePower consumption Emission EMI and Safety CertificationsUnpacking InstallationAttach the adhesive rubber pads to the bottom Rack MountingAttach the mounting brackets to the Switch Connecting Network CableAC Power Front Panel LED IndicatorRear Panel Rear panel of the SwitchUnderstanding LED Indicators Power and System LEDsBlinking Supported web browsers Installing the SmartConsole UtilityMenu Toolbar SmartConsole Utility FeaturesPage Discovery List Definitions of the Discovery List featuresMonitor List View trap Definitions of the Monitor List functions and termsTrap information Device SettingThis space has been intentionally reserved for notes Firmware Upgrade Web-based Utility LoginLog in screen Tool Menu Tool MenuTool Menu Configure Backup and Restore Tool Menu System Reboot Setup MenuSystem Trap Setting System System SettingSystem Trap Setting System Port Setting System Port SettingSystem Snmp Setting System Snmp Setting System Password Access Control System Password Access ControlConfiguration 802.1Q Vlan Configuration Jumbo FrameConfiguration 802.1Q Vlan Default Setting Configuration 802.1Q Vlan Example VIDs Configuration Igmp Snooping Configuration TrunkingConfiguration Igmp Snooping Configuration Page Configuration Igmp Router port Settings Configuration Igmp Multicast Entry Table Configuration Spanning Tree Configuration 802.1D Spanning TreePage Configuration Port Mirroring Configuration Port MirroringSecurity Safeguard Engine QoS 802.1p Default PrioritySecurity Broadcast Storm Control Security Safeguard EngineSecurity Broadcast Storm Control Security 802.1X SettingQoS 802.1X Setting Page Security Static Mac Address Security Mac Address Table Static MACSecurity Dynamic Forwarding Table Security Mac Address Table Dynamic Forwarding TableMonitoring Statistics Monitoring StatisticsMonitoring Port Statistics