Cisco Systems Cisco ME 3400 manual Enter an enable secret password, and press Return, Plain text

Appendix D Configuring the Switch with the CLI-Based Setup Program

Entering the Initial Configuration Information

Step 3	Enter an enable secret password, and press Return.
	The password can be from 1 to 25 alphanumeric characters, can start with a number, is case sensitive,
	allows spaces, but ignores leading spaces. The secret password is encrypted and the enable password is
	in plain text.
	Enter enable secret: secret_password
Step 4	Enter an enable password, and press Return.
	Enter enable password: enable_password
Step 5	Enter a virtual terminal (Telnet) password, and press Return.
	The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces, but ignores
	leading spaces.
	Enter virtual terminal password: terminal-password
Step 6	(Optional) Configure Simple Network Management Protocol (SNMP) by responding to the prompts.
	You can also configure SNMP later through the CLI. To configure SNMP later, enter no.
	Configure SNMP Network Management? [no]: no
Step 7	Enter the interface name (physical interface or VLAN name) of the interface that connects to the
	management network, and press Return. For this release, always use vlan1 as that interface.
	Enter interface name used to connect to the
	management network from the above interface summary: vlan1
Step 8	Configure the interface by entering the switch IP address and subnet mask and pressing Return. The IP
	address and subnet masks shown below are examples.
	Configuring interface vlan1:
	Configure IP on this interface? [yes]: yes
	IP address for this interface: 10.4.120.106
	Subnet mask for this interface [255.0.0.0]: 255.0.0.0
Step 9	Enter Y to configure the switch as the cluster command switch. Enter N to configure it as a member
	switch or as a standalone switch.
	If you enter N, you can configure the switch as a command switch later through the CLI. To configure
	it later, enter no.
	Would you like to enable as a cluster command switch? [yes/no]: no
	You have now completed the initial configuration of the switch, and the switch displays its initial
	configuration. This is an example of output that appears:
	The following configuration command script was created:
	hostname switch1
	enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
	enable password enable_password
	line vty 0 15
	password terminal-password
	no snmp-server
	!
	no ip routing
	!
	interface Vlan1
	no shutdown
	ip address 10.4.120.106 255.0.0.0
	!
	interface FastEthernet1/0/1
	Cisco ME 3400 Ethernet Access Switch Hardware Installation Guide
OL-7677-04		D-3