Cisco Systems CGS252016S8PC manual Connecting Devices to the Ethernet Ports

Chapter 2 Switch Installation

Connecting Devices to the Ethernet Ports

Figure 2-23 Removing the SD Flash Memory Card

.

Step 5 Push the replacement card (upside down) into the slot, and press it firmly in place. The card is keyed so that you cannot insert it the wrong way.

Step 6	Begin replacing the cover by placing the SD slot cover tabs into the hinge.
Step 7	Close the cover, and use a ratcheting torque number 1 Phillips screwdriver to torque the screw to
	4.5 in-lb.
	Table 2-1	Ethernet Cables (Auto-MDIX Disabled)
	Device		Crossover Cable1	Straight-Through Cable1
	Switch to switch		Yes	No
	Switch to hub		Yes	No
	Switch to computer or server		No	Yes
	Switch to router		No	Yes
	Switch to IP phone		No	Yes

1.100BASE-TX and 1000BASE-T traffic requires twisted four-pair, Category 5, Category 5e, or Category 6 cable. 10BASE-T traffic uses Category 3 or Category 4 cable.

Connecting Devices to the Ethernet Ports

This section covers the following procedures:

•Connecting to the 10/100 and 10/100/1000 Ports, page 2-25

•Connecting to the 10/100 PoE Ports, page 2-25

Cisco CGS 2520 Hardware Installation Guide

2-24 78-19377-02