Cisco Systems SFS 7000D, SFS 7000P manual Running a LED Test on the Power Supply, Start the test

Chapter 6 Hardware Diagnostic Tests

Running Power Supply Tests

Running a LED Test on the Power Supply

You can use the LED test to identify a specific power supply by entering these commands:

SFS-7000P> enable
SFS-7000P# config
SFS-7000P(config)# diag power-supply 1
SFS-7000P(config-diag-power-supply-1)#	test led
SFS-7000P(config-diag-power-supply-1)#	start
SFS-7000P(config-diag-power-supply-1)#	stop
SFS-7000P(config-diag-power-supply-1)#

Running a Self-Test on a Power Supply

To perform a diagnostic self-test on a power supply, follow these steps:

Step 1 Determine the ID of the power Enter the show power-supply

supply that you want to diagnose, if you do not already know the number. command.

SFS-7000P#show power-supply
=====================================================================
			Power-supply Information
=====================================================================
ps	type	admin-status	oper-status	utilization	voltage
---------------------------------------------------------------------
1	AC	up	up	n/a	48
2	AC	up	up	15	47

Step 2 Specify the type of test (self-test is chosen by default) by entering the diag power-supplyid command.

SFS-7000P> enable

SFS-7000P# config

SFS-7000P(config)# diag power-supply 2

SFS-7000P(config-diag-power-supply-2)# test self-test

Step 3	Start the test.
	SFS-7000P(config-diag-power-supply-2)# start
Step 4	Display the progress of the test by entering the show diag fan command.
	SFS-7000P(config-diag-power-supply-2)# exit
	SFS-7000P(config)# exit
	SFS-7000P#show diagnostic power-supply
	======================================================================
	Diagnostic Tests For Power Supply
	======================================================================
	module-type : power-supply
	module-number : 2
	test : self-test
	iterations : 1
	action : start
	result : success
	percentage-completed : 100
	result-string : Power Supply Self Test Completed, Final report : Passed=1,
	Failed=0, Total=1
Step 5	Display any errors that appear in the result string by entering the show diag fru-errorcommand.
	SFS-7000P#show diag fru-error
	Cisco SFS 7000P and SFS 7000D InfiniBand Server Switches Hardware Installation Guide
OL-10853-01		6-7