Cisco Systems 3650 manual Uplink Ports LEDs, Color PoE+ Status

Chapter 1 Product Overview

Front Panel

Table 1-7	PoE+ Mode LED
Color		PoE+ Status
Off		PoE mode is not selected. None of the 10/100/1000 ports have been denied power
		or are in a fault condition.
Green		PoE mode is selected, and the port LEDs show the PoE+ status.
Blinking amber		PoE mode is not selected. At least one of the 10/100/1000 ports has been denied
		power, or at least one of the 10/100/1000 ports has a PoE+ fault.

Uplink Ports LEDs

The four uplink ports have four status LEDs. Each port LED is labeled according to its SFP and SFP+ module status.

For SFP ports, a G(x) labeling nomenclature is used, where G = 1 Gigabit and x = the port number. The The G(x) label appears to the left of the uplink port LED.

For SFP+ ports, a TE(x) labeling nomenclature is used, where TE = 10 Gigabit and x = the port number. The TE(x) label appears to the right of the uplink port LED.

An SFP+ module ports has two labels, G(x) and TE(x), because it supports both SFP and SFP+ modules. The uplink port labeling layouts for the various switch models are:

•Four uplink port LEDs labeled G1, G2, G3, G4—This labeling represents four ports supporting SFP modules.

•Four uplink port LEDs labeled G1, G2, G3, G4 and two right side uplink ports LEDs also labeled TE3 and TE4—This labeling represents two ports (left side) supporting SFP modules and two ports (right side) supporting SFP and SFP+ modules.

•Four uplink port LEDs labeled G1, G2, G3, G4 and TE1, TE2, TE3, TE4—This labeling represents four slots supporting SFP and SFP+ modules.

Figure 1-6shows an example of an uplink ports LED arrangement representing two SFP and two SFP+ ports (Catalyst 3650-48FD-S switch model).

	Catalyst 3650 Switch Hardware Installation Guide
1-14	OL-29734-01