Cisco Systems 3650 manual Enter a host name for the switch, and press Return

Appendix C Configuring the Switch with the CLI-Based Setup Program

Entering the Initial Configuration Information

		At any point you may enter a question mark '?' for help.
		Use ctrl-c to abort configuration dialog at any prompt.
		Default settings are in square brackets '[]'.
		Basic management setup configures only enough connectivity
		for management of the system, extended setup will ask you
		to configure each interface on the system.
		Would you like to enter basic management setup? [yes/no]: yes
	Step 2	Enter a host name for the switch, and press Return.
		On a command switch, the host name is limited to 28 characters and on a member switch to 31
		characters. Do not use -n, where n is a number, as the last character in a host name for any switch.
		Enter host name [Switch]: host_name
	Step 3	Enter an enable secret password, and press Return.
		The password can be from 1 to 25 alphanumeric characters, can start with a number, is case sensitive,
		allows spaces, but ignores leading spaces. The secret password is encrypted, and the enable password is
		in plain text.
		Enter enable secret: secret_password
	Step 4	Enter an enable password, and press Return.
		Enter enable password: enable_password
	Step 5	Enter a virtual terminal (Telnet) password, and press Return.
		The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces, but ignores
		leading spaces.
		Enter virtual terminal password: terminal-password
	Step 6	To configure the country code, enter yes and press Return.
		Do you want to configure country code? [no]: yes
	Step 7	Enter the country code, and press Return.
		Enter the country code[US]:US
	Step 8	(Optional) Configure Simple Network Management Protocol (SNMP) by responding to the prompts. You
		can also configure SNMP later through the CLI, Device Manager, or the Cisco Network Assistant
		application. To configure SNMP later, enter no.
		Configure SNMP Network Management? [no]: no
	Step 9	Enter the interface name (physical interface or VLAN name) of the interface that connects to the
		management network, and press Return. For this release, always use vlan1 as that interface.
		Enter interface name used to connect to the
		management network from the above interface summary: vlan1
	Step 10 Configure the interface by entering the switch IP address and subnet mask and pressing Return. The IP
		address and subnet masks shown are examples.
		Configuring interface vlan1:
		Configure IP on this interface? [yes]: yes
		IP address for this interface: 10.4.120.106
		Subnet mask for this interface [255.0.0.0]: 255.0.0.0
	Catalyst 3650 Switch Hardware Installation Guide
C-6		OL-29734-01